Recent content by woolly

ewded that's a good idea well worthy of consideration .. i am in the uk and 3d print for a hobby but my 3d drawing cad skills will let me down here

haven't seen it mentioned but does the wiper assembly move up and down with the head height so the wipers wipe correctly for each height and got stuck on a higher level

possible from past experience the main ribbon cables failing and or muck or bit of vinyl in the actuator which is the cup shape bit next to the blade holder in side are fine winding's so a lot of care required . check for free up down movement of the actuator with the machine switched off. just...

i would have asked it if it wanted a 5 min or 10 min argument ... ... sorry back to thread..

lower the cut and up speed, sharp knife, add more rollers if you can. also thicker materials do not like bending over the bed like cast types which comes back to you adding a surface each side for the material to slide on to and as you say reduces the weight problem i did this with a graphtec...

print the spot colour sheets using the profile and quality you need from versaworks then chose the spot colour then dial in the number very useful when chasing colours

by the looks of your test print you will need to adjust the position manually of the m+y head before any of the electronic adjustments info should be in those pdfs. well worth the time and effort to get right.

haven't fully wrapped one but done fair amount of protection stuff i don't think i would even try got to be easier to paint it then add some colour or printed bits, easy to make and digitize templates for down tubes and fork ends, bit of dayglow a few sponsor logos will soon brighten it up have...

from the uk so had to look up pontoon boat, i can see the attraction of stability and use in shallow water but they are ugly

i run a vs540 wt mt and yes its slow compared to normal prints approx half speed.. fastest for that type of head is 2xcmyk roughly half it if light inks used and again if wt mt. you have to have a regular use for the wt mt colours else it will be a profit drain and a load of hassle. i have just...

that print head is dirty correct to change the wiper

i had one of those when new and still have a pc60 but as frank says not worth your time really,, as a cutter only its slow by today's standards but adequate for small jobs. the print drivers will only work on a xp system but to drive as a cutter only most cutting program's will have drivers for...

flexi or versaworks rip if vw then on the layout page. show a picture of the miss printing

off set in the rip or move the origin on the printer over.

3d print an adapter for a standard pen