• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. F-2 fuse replacement on an SP-300V questions

    I tinned the wires on the fuse holder and then cut them back at a steep angle (made a point). Then soldered the wires to the fuse. My fuse holders were 16g iirc. Now that you mention electrical fittings, it might be easier to solder a spade to the wire and cut one leg off and solder the other...
  2. F-2 fuse replacement on an SP-300V questions

    My fuse holder and fuse both say 12/120/250V. The fuse is 1.6A. Typically most components on a circuit board do not run at 120VAC. Most circuit boards condition the 120VAC coming into it, down to 3VDC or 5VDC. So a 12V fuse and fuse holder should be fine. Remember that 2A fuse you bought is...
  3. F-2 fuse replacement on an SP-300V questions

    I soldered an inline fuse holder to the existing blown fuse and installed a 1.6 amp glass fuse. Picked up the fuse and fuse hold from the auto parts store down the street. I did not remove the main board to do it; Just unplugged the power cord before I started.
  4. How to check for a bad fuse?

    I used a volt meter on either side of the fuse. Had voltage on one side and no voltage on the other side. There was no visual indication the fuse was blown. Took me longer to find the fuse than test it. They are very small.
  5. F-2 fuse replacement on an SP-300V questions

    F-2 is a 1.6amp quick blow fuse. Available from Roland as a separate part. They are tiny; need a steady hand to solder those.
  6. How to check for a bad fuse?

    Yes. I did the same thing. Fuses available through Roland; or solder an inline fuse around the burnt one.
  7. Old Polaris Font Help

    Have it. Send me an email asking for it cggrafx@shaw.ca
  8. Question Roland sp300 not connecting with versaworks

    Seriously? Versaworks and the original SP300 work fine together. Once I had to unplug the usb cable and plug it back in on my new Windows10 computer before Versaworks would see the SP300, but I've have to do that from time to time with very usb device I've ever had from Windows XP and up.
  9. Hockey arena rink boards

    We apply the design to 1/16 polystyrene; if printed no laminate. Hockey arena mounts the polystyrene sheet to the boards and mounts clear lexan over the polystyrene.
  10. AI to WinPCsign losing detail...

    Convert text to outlines in AI and save as AI 8 or earlier. WinPCSign has issues importing AI version 9 and later files:doh: Also WinPCSign treats compound paths inconsistently when importing; some it gets right, some get import as two outlines on different layers.
Top