Recent content by anwarshah

I did just that also at the damper side on the cyan ink line. There wasn't much ink there until I sucked some. I still had the same problem. After checking the new cyan damper, it looked suspicious and barely had any cyan ink in it, so I replaced it again and sucked the ink line. This time it...

It does print black,cyan,magenta and yellow from left to right. Cyan comes out very light almost invisible. My lines are connected as shown in the sketch. The cap tops are new. I heard about cross contamination somewhere, but on explanation as to what it is and how to solve it. Just the two...

I did double check, all the lines are correct. When replacing the dampers, I did it one at a time so not get mixed up. Thanks for your response

Hello, My SP300V prints dark red instead of black and light yellow instead of cyan. I just replaced all the dampers and also the cap tops. All the installation was done correctly. I did a solid bar print around 1x10 inches in black and another in cyan both at 100%. After many tests, I still...

Thank you IsItFasst. By seals you mean around the dampers? Many thanks.

Thank you for your input Unclebun. If it's clogged, is the solution to replace the dampers? Can the line be clogged also, if so how is it de-clogged? Many thanks

Hello, Does anyone know what the problem is for getting a darker print color then lighter on the same run or any as shown in the picture? It happens when the machine is powered up, starting with a dark color and getting lighter. I've been using the same file for a long time until just now the...

yes please, it is for SP300V, here it is sabirshah33@hotmail.com. many thanks

Does anyone know the procedure of replacing the print head manifold on the Roland SP300V? Are there and precautions to be observed and especially does the print head need to be re-calibrated? Many thanks in advance

Any suggestions what profile to use in Houston?

currently the heat for the Print is 37 and for the Dryer is 40. Change both, if so by how much. I forgot to mention, the material is around 2 months or less old. If you want to see the test print pics... https://www.dropbox.com/sh/zu29doolzoov99x/AABSxYJSvWzhQPozj0JWsX5Ea?dl=0

Here is the link to the pictures... https://www.dropbox.com/sh/zu29doolzoov99x/AABSxYJSvWzhQPozj0JWsX5Ea?dl=0

Can anyone help with a problem of grainy print on Roland SP-300V. I am using orajet 3551 for a long time with the color profile from Oracal also. Perfect media no problems. Recently I moved the machine from PA to TX and did go thru the procedure outlined in Rolands SP-300V manual when...

How do you disable the antivirus in Win 7?

Rvw Mine is Win 7, SP1. I just did your last suggestion and will see what happens when Win 7 is shut down and rebooted. I have Norton Antivirus installed, but not renewed.