I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
In flexi, both line segments on either side of the point have to be a curve for you to be able to pull a control on either side. If one side is a curve and one is a straight line then you will only be able to adjust the curve from one side of the point. Once you change both sides to a curve...
We normally stock 54" 3850, but I have one job where I need around 10-15 feet of the 60" material. Does anyone carry it and would you be willing to sell/ship it to me? I just don't want to order a 150' roll for this one job. I would prefer the oracal 3850 as we have used it on previous jobs...
I have had a gerber envision 15", a summa 30" and two graphtec 54". While the graphtecs can cut very fast, the quality is not quite on par with the summa or sprocket fed envision at the higher speeds. As someone pointed out the biggest drawback with the graphtec's is that it will yank on the...
Heyskull,
Here is a link to a previous post about that same issue. Hope it helps.
http://www.signs101.com/forums/showthread.php?42265-JV3-message-error-07-head-*
Peanut
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.