Recent content by BANNERS2GO

Cyan print head ran out of ink during a print. Replaced both ink cartridges and pulled ink through with a syringe. The regular test print comes out fine but when printing some magnets with a blue background there is banding on the first half then it looks good. This goes the whole width of the...

I know this is late but you need the printer driver from efi. It is a flora software. If you dont have it going by now pm me and I can send it to you.

Check head cables. Manually pull ink through with a syringe.

Thank you!!

Thank you in advance!

Thanks!

The font of Lawn Service Thanks for any help.

It is either your encoder sensor or strip. Try cleaning or replacing them.

Flame Thrower. No but seriously. If white on the back would be fine just throw a roll on your laminator and line them up and put them through. It would end up saving you a little if you had some cheap labor and a large quantity. Like everyone else said if you only have a few don't waste...

Re: need H700 help check the all heads, sericol uv, al5, set, write and wait. restart program and test.

One of my good customers needs to get a Food Truck wrapped in Vegas but I am in Florida. It is a complete wrap and I think they are wrapping the front windows as well. I attached some pics of the truck the way it is now. Need an installer to install my vinyl or a company that can do the...

Thanks for the replies. I will probably have to call and maybe get a small sample mailed to me so I can see if it is actually the black fiberglass screen they are printing on w/ white ink as a base coat or if it is actually just a mesh banner material. I wouldn't be competetion for anyone...

Looking for a material I can print on with either eco-solvent or UV ink that I can put in a pool cage and it will still breathe and let some light through. I've considered doing a mesh banner material but the back of it wouldn't be black. Any suggestions?

And as far as ink goes. We would prefer anything but true solvent. So UV, Eco-solvent, Latex. And the machine would be used mainly for banners.

We have a 54" Roland and a 72" Rastek flatbed currently and are looking for a wider printer at least 100" but would prefer a 10'. I have done some reasearch but would like some recommendations from actual users.