I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I found that on my plotter but unsure what settings to put it at.. I've tried just about everything.. Everything has been cutting out nice until now.. The small letters are starting to cut more jagged, I've changed the blade and can't figure out the problem there..
I'm cutting out some very small standard style captital letters little bit less than 1/4 inch and having a hard time finding the correct setting that will be the most effective for weeding.. I am using a 60 degree blade with Oracal 651 Vinyl and currently have my settings on
No.Tool : 09U...
Yah It's on the front page of there website http://www.matcotools.com to left hand. I can make it work with what I have I just need that font style now and unsure what it is..
Hi guys,
I am looking for the Matco tools logo for one of my clients race truck.. I could not find it anywhere, I checked out brands of the world and a few other sites but no luck. So I don't have to spend a bunch of time redoing it.. Would be greatly appreciated!
Thanks for the help.. I Ended up finding my problem though going through the file.. I had copied another layer on top and didn't realize it was there..
I'm having problems with very small letters coming up on my Graphtec CD3000. I switched to a 60 blade to see if that would help.. It was okay at first but went back to pulling letters up again and getting sloppy cuts.
Here is my current setting cutting out oracle 651
TOOL 09U
OFFSET -1
FORCE 14...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.