Recent content by brainnew

over spray Take a look to the part connection between damper and print head manifold, it might have leak because cracking. Its happen to my print head last month. I have replace new print head.

Encode reader Thanks LarryB, I am busy then read your recommend late. I will take a look this part. Thanks again Brainnew

Hi all, After I did the bias adjust, and print cut adjust the printer start print the registration print cut mark not as high quality, see the attached. My printer is Roland SP-540v How to void this. Thanks for all advise. Brainnew

The issue resolved! Thanks Before I have been enter service to adjust but its not made any changing. With you instruction I fixed its today. Thanks a lot Brainnew

The depth of stand SP-540v The depth of stand SP-540v= 29.1/8", the printer without stand approximate 21". Hope it's help you some. Briannew

Hi all, My black/cyan gone, I have replaced fuse but after that the print test show the white gap between cyan and magenta! Any one have this experience? I have been did bias adjust by hardware and software but nothing improving better ! My printer SP-540V, only me run this printer almost 9...

Distort and over spay printing Hi J Hill Designs, My printer SP 540v, its just happen as over spray the cyan only and distort the image after I use the brand new cleaning tool with alcohol to clean the encode strip Which tool us used to clean encode strip? Thanks Brainnew

print head problem print test pattern not even I have been soak the head, all damper, sponge, scraper, pump line just replace two month ago... Its time to replace a new printer head Thanks for all your time and suggestion

Print pattern not even It still printing but I have print at high quality...to reduce the banding. I will try to soak it later, I should buy new print head, its ready for worst time. Thanks for all your suggestion Brainnew

print pattern not even Thanks Rjssigns for your ideal. Its may strike to the edge of media, its happened one time. I used third party ink a long time, even the black and blue. I would waiting more suggest before replacing a new head. Thanks again. Brainnew.

Hi all, My printer Roland Sp 540v,the magenta pattern test print out not even!!? What happen, need your help ideal how to fix. See the attached pic. Thanks Brainnew

Hi all. My Roland Sp 540V, after test and print, I smell something burn in the printer. I stop and switch the printer off. Since their the yellow completely quit, I tried switch the magenta cable into yellow and magenta to yellow. Magenta and yellow quit print out, it just show the black and...

Clip tube to waste bottle Hi all, Last few days my Win 7 could not boot. I'v just fixed it and back to forum. At this time, I have use a clip to clamp the tubes to waste bottle. It's help some... I think I will make the waste tube longer to raise the level same high to the ink line. This...

Hi all, The ink drain come back after 72 hrs. delay !? Magenta ink drain and show three quater on the waste bottle today... not happy yet :-((

The ink drain to waste bottle have fixed. Hi all, All last night and today, the issue ink drain have been fixed. I thinks the cause is the rubber washer connect to the dampers Thanks for the supports :thankyou:Brainnew:wavingflag: