Recent content by Bretbyron

Grimco, Nglantz and all sign supply companies will give you a quote with discounts if ordering blanks in bulk. Grimco came out cheaper when I ordered (200) 12x18 .040 w/ .75 radius and holes drilled where I determined.

https://www.corelnaveia.com/2008/12/coreldraw-x3-hotpatch-1-sp1-sp2-font.html

After over a year I finally found the patches to fix the fonts in Corel Draw X3 Installed Service Pack 1..then 2....then....Font Nav https://www.corelnaveia.com/2008/12/coreldraw-x3-hotpatch-1-sp1-sp2-font.html

Three steel monument signs need to be resurfaced and painted. I plan to use Matthews Acrylic Polyurethane Ultra Low VOC for repaint. Customer has requested an Anti-graffiti surface or for them or to be powder coated. I found VANDLGUARD ISOFREE URETHANE NON-SACRIFICIAL ANTI-GRAFFITI sprayable...

Thanks for the suggestions. I'll look into them more and report back. I do remember a program awhile back that was Excel based, i'll see if its still around. What sucks is Shopvox loads products from 2 of my apparel vendors, but no sign vendors.

Been struggling with Shopvox for 8yrs! It's F'n killing me. It's ok with screen printing, but loading new sign products and then being able to find them in all the drop downs is a living nightmare. An estimate with multiple items and services should not take 4hrs. to two days. Otherwise, it's...

Installed? I've been between 12-15 installed.

Installed this Driver: Mimaki Driver Ver.5.5.0 (32bit) 5.5.0 10/04/2021 64.51MB Had the USB driver in it. Had to reset communications dialog in Finecut and we are back up and running! Thank you so much for your time gentlemen. I don't know what I would have done without this forum for...

I'm running windows 7 32bit and Corel 13. The computer acknowledges when the USB cord is plugged and unplugged from the cutter. I feel it has something to do with the windows update. I restored to last week, but no go still. Cutter itself is all systems go on its end.

Seems Windows did sneak in a "Critical Update" yesterday. Damn!

I have Finecut 8. Never had this problem in the 8+ years of running this setup.

I'm still not seeing a specific USB Driver. Should I be updating all drivers? Cutter was working 2 days ago through Corel w/ Finecut. Today "no response from plotter" when trying to cut. Checked port is functioning, rebooted everything, checked settings in Finecut, connection test failed...

I am not seeing a USB Driver here: https://mimaki.com/product/cutting/c-roll/cg-srIII-series/download.html Am I looking in the wrong place? TIA

https://www.manualslib.com/manual/1264353/Mimaki-Jv33-160.html

Shopping Cart Ad.