Recent content by Colt67

old (well not too old) dog teaching himself new things the drawing(hat) i drew > I have tried joining the nodes with join curves with upper right docker (used 0.0-0.3 as closure) and have whole image selected while trying to join the nodes but the nodes are not joining correctly. 2 pics...

thanks JB I 'm concerned of the metal gear having the grooves in it (is it suppose to have the teeth grooved out ). the black jack shaft gear is plastic >>and plastic should not wear out the metal gear. Does anyone have a picture of their good Y motor gear to compare?

I do not think 15plus motor is the same but this is the motor M062-LS-557E and gear has 16 teeth

Looking for a good used Y axis motor with gear for Gerber gs750 plus plotter M062-LS-557E Thank you for any help

Gerber 750 plus I am having a problem with the plotter-pen plot is showing its off. 3 Pictures are attached Any ideas of where I need to check and correct on plotter Thank you

new issue> vinyl being cut on 750 plus> try cutting test plot Pentagon and cuts deep enough to weed easy and travels extra 2 inch at bottom of Pentagon (at end) and then I tried cutting a design and knife cuts lines from one area to another in travel to a destination ruining design> tried...

got it to black> it was red thanks pros

this was set up for me . no 15 " plotter installed only 750 i will look through this set up as you have mentioned and get back with you thanks

New at learning > using 2.0 composer and can not remove a cut line in gsplot for a stripe design. Pen plotting first to make sure ok > then plotting vinyl the design is 21.486 Height and 93.567 in length open design in composer gsplot/quick plot and the design is showing 2 panels 1) 11.8 and...

these other files that do not open in composer are also not opening in AI (unknown format)

using adobe illustrator cs3 (2007) and CorelDraw 13 (2005) 3 files of cdr made into AI > do open in composer but the others do not (types of files are AI adobe illustrator artwork 13.0 and the cdr is CorelDraw x3 graphic) is there something in the design file that is making it not open in...

corel does not have eps but illustrator does> converted one cdr file in illustrator to eps and tried importing in composer but error says encountered problem and will shut down can not open cdr files in composer -error msgs for some files > unknown error encountered while importing or...

new at this (learning to cut files to gerber 750 plus plotter) and need some advice on trying to open .cdr files made with CorelDraw X3 or cdr converted to AI files in Composer 2.0. > get errors. Some files open and some do not. tried some things but not working Thank you in advance for any help

New to this. used CorelDraw x3 at times to design car stripes and now want to cut the designs on 750 plus plotter. Need some tips on taking design to cut on vinyl from Coreldraw (no printing of colors, just cutting on colored vinyl)> Adobe Ill(if needed) >to composer and to plotter to cut my...