• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Creek Bank

  1. SP-300v

    Have had issues with build up on the roller bar, that causing material to pull to one side. If you are using printing the black square and then cutting that out remove it from the material and lay it on a contrasting color, look it over good and even use a magnifier, if there is any white...
  2. Connect Roland GX-24 with Versaworks

    It will work, that is a combo that I run. Can't remember how I got it to work, I remember uninstalling the GS-24 several times before I found a sequence that worked. Seems like did the search first for GS-24 with USB unhooked then plugged it in an it found it... not sure. Make sure you have...
  3. Need Help BN-20 Location of Registration Marks

    Hi All, After the latest VersaWorks update to 6.10.0 the BN-20 started printing the registration marks with the small arrow directly next to the print rather than the roughly 1/4" gap that used to be there. Therefore when I try to cut via registration marks on the GS-24 all cuts are about 1/4"...
  4. Roland print and cut alignment

    I have had this issue a few times and it has always been a build up of adhesive or something stuck on the feed roller. Clean carefully.
  5. Question Font Request

    Racing is "Road Rage"
  6. Heat transfering to 100% Polyester Jackets.

    I have done several of these with HTV with only 1 small issue which was print starting to fall off. I always wipe area with alcohol first as many of them are also treated for stain resistance. I also use a light pressure.
  7. BN-20 Cleaning during print

    Hi All, Checking to see if someone has some info that may help me out on this one. This printer has been going through a large volume of ink. I just printed 90 12" x 12" full color signs and it used a nearly full 220 cartridge or each color and the waste tank went from 15% to full. According...
  8. Fun Font I've never seen

    Yes Expo flip the "s" upside down
  9. Need Help Font Help Please!

    Keep on Truckin is pretty close. https://www.dafont.com/search.php?q=keep+on+truckin
  10. Need help. My BN20 just keep beeping and flashing.

    Glad you got it figured out.
  11. Need help. My BN20 just keep beeping and flashing.

    I have had the BN-20 give false info on ink capacity but never when empty. Is the head in the parked position? Did you try removing the media and putting it back in? With the media out inspect the feed roller good. One time I had a piece of tape wrapped around the feed roller and that made the...
  12. Need help. My BN20 just keep beeping and flashing.

    I have had this happen a few times and when it does usually when I shut down Versaworks and then restart it will be fine, other times I have to shut off the main power on the BN-20 let it sit a minute and then turn it back on. One of the times it did it seemed like nothing was going to work...
  13. Creek Bank

    Small town print shop

    Small town print shop
Top