Recent content by Dan Berg

At 73 I have my fair share of gray hair so know a little bit about risk management. If they would only make these things a little more affordable to repair. $175 an hour is just not going to happen. Looking for new sensors and those I can install myself.

Except my sensors don't work so we cannot do any of the things you are talking about other than the possible jumper.

Go to my post just above yours about the same fan noise. The link has been added for a firmware update that shuts the fan off when the unit is asleep. Dan Berg

Yeah it worked. That squealing fan is gone. Thanks a million for the link.

What language version would this be? Don't want it to change anything to French.

That doesn't even closely match the version I just downloaded. It had a date of June. 2023. Just went to the website and checked. The only firmware available for the s80600 is the SA11B. Are you possibly outside the USA?

The word on the street was the new firmware SAO11B 1.16,9000 Firmware was supposed to silence the loud cooling fan, but is hasn't. Any one have this fan issue that the firmware has silenced it?

Known issue for ages. The new firmware is supposed to have fixed it but it has not worked and is still loud as ever. In sleep mode it is supposed to turn off but it doesn't.

Compass Micro sheet, protection, IMS for Epson SureColor S80600 Part number: 1843036 Reference number: 654 Stock/Special Order: Stock $14.08 Stock View Details

Just received the new one. $14 plus shipping. all is good.

Yes I ran my solvent covered swab over it and of course the solvent loosened the adhesive enough for it to fall off. I stuck it back on and it has stayed tight for about two weeks but I will either get another one or make one myself.

I stuck it back on with the adhesive that is on the edges. Pretty sure I know what happened and it was my fault. When I did the manual clean I may have brushed near that area and the solvent on the swab loosed/ dissolved the adhesive.

Is it a cover for the paper edge sensor, anyone know?

I think I see where it may have come from. Can I just order another and put it back in myself. Should I not use this printer until I replace it? Just curious what the purpose is?

If I do the jumper I will keep it as it says above. It is only me here.