Recent content by dbydprint

I have the same error on the 1604 / just stops at 98%?

A tech finally solved - it was the head carriage, there are 4 plastic clips in the back 2 were broken at the bottom ( no clue how this could've happened). The up/down lever is on two little springs and the springs were actually raising the carriage up just slightly in the front so the head was...

I tried pulling ink in to the dampers and the tubes and it pulled ink - looked mainly black-blue is all I seen - nozzle check and black and blue printed - no yellow or magenta - I was happy at this point (oh, maybe just a good cleaning) - a day later after head soaks it's back to the same thing...

I have not - when this happened on your end was all 4 color not flowing (that is currently my issue)?

I appreciate it - have measured and all seems pretty level - but still not pulling the ink through the capping station (2nd capping station so can pretty much rule it out).

no ink flow from head to maintenance station 1 week ago I noticed head clogs (minor but bad enough to cause poor prints) - after cleaning - then ink fills to head soaks no luck. I then noticed a clog in the tube the goes in to the waste / clean all tubes and the maintenance station well - but...

When I add contour to an image and send to print - here is my dilemma when sending multiple images it used to have a set of 4 registration marks around each image sent (2=8 10=40 registration marks and so on) now it only does four around however many sets of images I send - can you tell me...

I need to know what purpose a certain part is for and where I can obtain a replacement (if needed). The part the 2 heads sit in (in my machine is silver metal) - this has 2 clicking/sliding dials up front, and 1 on the right side, my issue is that the dial on the right side has been broken (a...