I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Yes the captop is fine, I replaced it anyway. I can draw ink through the damper and with heads off of captops I can pull air through captop line but when the printhead is parked I can't draw any ink at all. The captop has a good seal as well. I'm baffled by this. Is there any other scenario...
I've gone through everything and it's definitely the printhead. I just can't figure out how it could possibly be 100% blocked after sitting for only 4 days and before that I printed 60 feet of vinyl with no problems with the print. I'm trying to figure out why this has happened and what caused...
Dampers are good, I can pull ink through them but can't pull ink through the captop line. I'm wondering if it's possible that the ink is causing the problem and maybe the printhead is clogged because of that? But then again both colors?
Hello, I have a problem with the black/cyan head. The printer sat for about 4 days after printing about 60 feet of vinyl with no problems. I went to print the next job and noticed the color changing on the print leading me to beleive there was an ink supply problem. I did a test print then did a...
I'm begining to believe it's the cut carriage board or the servo board, I am trying to track down a servo board right now. Any info on where to find these boards would be greatly appreciated
The encoder strip was replace when this problem started. I tried putting some 30 inch wide vinyl and when the pinch rollers are down the cut carriage does not stop at the edge of the vinyl, It goes all the way to the farthest left before returning to the "home" position.
Hello, Did you ever get the pinch roller issue resolved? I'm having the same problem. I replaced the 15 pin cable-card and pinch roller sensor and still have the same problem. Any help would be greatly appreciated
Hello, Did you ever figure out what the problem was? I am having the same problem, I replaced both 15 pin cable-card and the pinch roller sensor and still have the same problem. Any help would be greatly appreciated
I've cleaned everything with alcohol. Looking at the sensor check pic it looks like the interupter is not getting any power. I performed a sensor check with pinch rollers up and down and took pics of the display and there is no * for the pinch roller sensor. I'm stumped.
Does anybody know of any technicians in northern Ontario, Canada? I have an SP540V and I get a "pinchroll error invalid right pos"
I've changed the 15 pin cable-card, and the sensor as well. I did a sensor check in service mode and Linear encoder check and linear calibration and no errors or...
Hello, I am trying to find a photo of the Washington Capitals hockey team sitting on the bench. I have a 40" X 240" knee-wall in my basement (Man cave) that I would like to wrap. Any help would be greatly appreciated
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.