Recent content by eesanopi

Hi Joe. As yo say, in this pictures all looks very good, so I can't help you with additional tips, my only advice is you need to be very observant to try to detect the failure when it is present, sorry. Edgar

Try this: Power up printer while pressing LEFT & RIGTH keys, after boot you will see in the display a parameter, pushing DOWN key you need to look for COMPY, if the value is positive try to change to 0, then look for WIPposY and do the same, after that press END until exit the all parameter...

Hi, I didn't have time to take pictures las weekend, but I did some trims from PDFs, I hope it will be useful for you Remove the cover in a red circle showed in picture 1, you'll see the ink lines attached to the cartridge valves through brass nuts (in picture 2 red arrow is pointing the valve...

Hi, do you need to reload CSV file to solve the problem, do you have it?

Sorry to hear that but I think is not the printhead, if the cap top is sealing good then you could have air bubbles in the line, it can be formed because a loose nut in the line, a damaged oring inside nuts, etc. When you do a hard clean vacuum pump removes the air bubbles, but they form again...

odshawaii, here the procedure if you still need it. Boot the printer pressing REMOTE + ENTER if you are not in permanent service mode, using UP & DOWN keys go to #TEST and press ENTER, look for CARTRIDGE VALVE and press ENTER again, you will see 8 dots in printer display, each menu represents...

QUOTE="SightLine, post: 1283668, member: 21518"]What firmware version is you machine running? If above version 2.30 boot the machine into the parameter change mode or boot it into the mode where the service menus are enabled. Go to Parameters, custom, and change the value of custom parameter #76...

Same problem in a V6.0 JV33, I did this recomedation and it's working now, I'm very happy, thanks to you. Regards Edgar

Hi VanderJ, Same error in one of my JV33, OEM printhead, all characters was displayed in Japanese today, yesterday we move the machine from one room to another, only displacing it in their own wheels. I did unplug and replug all the cables without success, I reloaded CSV file but only change...

Yes I can, but only on weekend, sorry but very busy.

did you check the adjust for the new cap top in #ADJUST menu? A test that I do is to use a syringe in the pumping line to "feel" if there is enough vacuum, first I switch on the cartridges valves in the #TEST menu. If the vacuum is not solid or it's lost quickly then you have to do adjustments...

I will try, thanks for the info. Regards

Hello, I want to upgrade a JV33 to V6.0 firmware, can somebody share the rom file to me? Regards Edgar

Hi, I'm pretty sure the problem is your new cap, maybe you need to adjust it using the #ADJUST menu. About he 3rd port with the blue stopper, sometimes this stopper is low quality and has a non-visible damage, to ensure there are no vacuum leaks I usually remove it and apply heat to melt the...

Hi, Thanks for your response, this machine is all mimaki original, until yesterday I was printing ok, I think MB is fried too, do you know some repair technician? Regards