Recent content by ejmoan

Hey thanks for posting this a while ago. Did you ever get an onyx thrive 11 driver? I mistakenly over wrote mine. Any help would be apprciated

Ok at the advice of the onyx team. I thought i had a printer issue on my hp latex 310 and overwrote my print driver when i uninstalled and re installed onyx. I am running onyx 11. Now Onyx says they no longer support it and wont give me the driver. Would like to upgrade to 19 but want to...

My problem is solved !! Thanks so much for all the info everyone. All of the suggestions are great. I learned a lot and would love to start perfing the larger thicker pieces that fall out due to size and weight. This would be a huge time saver Regarding the status of my issue... even...

Thanks for the idea. Do you move the tool to position 3? I i have had trouble dialing in Perf cutting on this material because it tends to drop our and jam things up. It is larger mx pieces. I am assuming you use a custom pattern that does leave the " hanging chad" things. Thanks for the...

Good thought it is a out 4 months old. When I am in my shop I will look at that closely. Thanks so much

It

Hello recently my after 3 years of use my FC8600 does not cut all the way through thick material and lam for mx. (Makes it through lam only) Been cutting for a couple years and just started happening. Thin material cuts perfectly. I have a new blade and just bought a new blade holder based...

When I was new and by myself my wife was very helpful.

Once it is laminated it can go in the basket if that works for you. One issue is you may have an over hanging edge of sticky laminate that may stick to your print. If it is a short run I would feed to a table or hold on to as it feeds. Ideally you need to be on the feed side to keep eye as it...

What type of laminator is it? We have a gfp 455th it has a roll that spins on the back side that we tape the edge of our material to and let it roll up on it as it feeds. Alternative could be a table that is the same height I use both.

I like 3m Ij35c is good and sticky for window decals we do laminate with 8508 3m as well.

On the material feed roll I leave an 8th inch gap so the cardboard roll can spin freely but not be floppy. I also do no tighten brake on the print feed roll.

I call that the boat wake effect. When you roll your roll down where the laminate touches it should barely touch the roll of vinyl. You would want to roll it down touch and go back and forth with the crank handle until you feel only slight pressure. You will want to tighted the brakes on the...

My Graphtec FC8600 54 inch is a workhorse for my company www.wraphouseindy.com . We do a lot of cut letters for vehicles and decals with it. You Will want to print most things 48 wide to allow registration marks which is put on your AI or coral file using the free plug in for cuttingmaster...