Recent content by espace-visuel

Hello, I tried this method on a CJV150-160 and it worked. I don't understand how to make a SOFT-OFF-ON. Thank you.

Exactly, but the problem is that the noise of the carriage when printing has become louder. I think over time it could burn the motor.

This morning I tried several times to adjust the tensioner and I was able to lower the belt by 2 millimeters no more. The main thing is that the belt no longer rubs at the top but it is not stable, when the printhead carriage is running, the belt goes up and down on the pulley. hope someone...

Yes indeed there is a pulley tensioner to adjust it, tomorrow I will and I hope that will solve the problem. I'll let you know as soon as possible. Thank you.

Good evening, Every time I try to put it back in its place, it rises upwards.

On the video you can see that the belt is at the top. It is not on its site.

sincerely I am afraid of touching the pulley at the risk of upsetting the carriage. i dont know if anyone has had the same problem as mine.

Please help me solve this problem !!!

Hello, thank you for responding to my request. Our machine has been installed for 5 years, it has not received any shock. I have a doubt, when I cleaned the encoder, maybe I pulled the belt too much. currently when the machine is running, the belt is not fixed on the pulley, it runs upwards and...

Hello everybody, We have a problem on our Mimaki CJV150-160 machine. the Y belt does not have a direct line, it goes up the side of the pulley when the carriage is running. you would have a clearer explanation by looking at the pictures. kindly please help me solve the problem.

Hi Jim, No physical damage and ink buildup. I haven't changed the 3 cap sponge for over a year.

#Mimaki #CJV150 causes problems and creates over spray at the edge of the print. we noticed that the printing test is bad with a curved alignment on black. we made several attempts to clean the nozzles, filling up ink, changing the Dampers, cleaning the encoder, but without any result We hope to...

Someone can help me

I hope it doesn't matter

Hello, for three days I have had the same problem. I tried all the cleaning modes as well as the nozzles wash for 5 and 20 minutes. I also noticed an incorrect alignment on the MAGENTA. Please help me. Mimaki CJV150-160