• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by geNe36

  1. How to setup my workflow? SAI Flexi HP Latex 365, Summa S1D160

    Summa Barcode Plugin for Illustrator (without RIP):
  2. Need Help Summa D160R - Random cutting depth

    Uneven cutting depth When the cutting depth does vary, then check the following: • Knife holder incorrect in tool clamp: the knife holder has to be put as low as possible in the tool clamp. • The floor may not be level. Because of this there may be torsion on the machine causing cutting depth to...
  3. NEED HELP PERF CUTTING

    https://signs101.com/threads/flexcutting-in-flexi-asap.158060/ Do go through this thread. There's a post to teach you how to do FlexCut (Perf Cut).
  4. FLEXCUTTING IN FLEXI ASAP

    There are two settings to note when dealing with thick materials. TurboCut: Default it is ON.. but when dealing with thick materials, this mode will not work very well. Length Calibration: If your cutting is misaligned, take note of this setting when dealing with thick materials. When material...
  5. Summa Barcode Workflow - Cutoff After Each Job

    This is a video on Summa's Roll Up Option
  6. Suggestions Summa D120 SE

    If budget is a concern, you might look into D140FX and see if it fits your work and needs.
  7. Discussion Summa contour cutting off 0.2mm

    OPOS Calibration: This is to adjust the offset between your knife and the OPOS Sensor. Do this everytime you change your knife. Knife Offset: This is to adjust the offset between the knife CENTER to the knife TIP. Maybe you can adjust in the graphics cutting file instead? Offset it there or...
  8. summa firmware problem

    Below is the instruction for upgrading firmware for S CLASS 2. Not quite sure is it the same as yours. For your REFERENCE ONLY. An active internet connection is required on the computer used to perform the firmware upgrade. Check Current Firmware Version You can check the current firmware...
  9. D140 - Cutting Accuracy

    I'm not sure if the Sheet Cut function you've mentioned is it OPOS SHEET MODE. I'll share a video on this function. In order to align, a piece of vinyl is being taped on the side.
  10. Need Help Summa F1612 Reinstalling Flatbed software onto new PC

    But anyway, you may like to try this instead: You may want to follow the procedure below to make sure all files are properly “removed” before you start with the installation of the software. Instead of “removing” the old data Summa does recommend to move all program files data to another...
  11. Need Help Summa F1612 Reinstalling Flatbed software onto new PC

    Why dont use the latest version of GoProduce? Just came out not long ago.
  12. Summa D140FX vs D140R / D160R vs Something else

    D140FX is basic enough for your work. Thicker materials may be a bit slower as it only has the X motor... btw, HP OEM this model... It is as advertised: No gimmick
  13. Summa D-140 (Failed to enter) error when turning on

    This message appears on a SummaCut with network interface (SummaCut RL). Make sure only one communication cable is connected to the machine (either USB or Network - NOT both). Also try to set the IP address in the router for the cutter to a static address, use the same address in the cutter...
  14. Caldera Barcodes and Summa Cutters

    Do take note that the directory of the barcode files (*.plt). It must be the same at the Summa Cutter Control Directory set.
  15. G

    :)

    :)
Top