I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
The only way I could improve it is to slow the print down - normal speed and keeping the number of passes at 14.
On a side note does the higher heat keep the roll flat/smoother? As sometimes the roll is more warped at 35 deg C pre and 35 deg C print so I drop them both to 30 deg C and the...
Thanks for the suggestions guys.
Heaters are on as I have tested them from 30-50 deg C
I recalibrated the print (drop pos correct) and media comp
Adjusted the height of the head to lowest position
Not tried uni direct but I have always printed in bi direction and never had mottled print
default...
I have noticed the print quality of the Mimaki has gone really mottled and the test print doesn't seem as crisp as it use to. The black seems to seep into the yellow.
Ignore the smudge the material wasn't very flat.
Using corel draw to Rastelink
have played around with the heat settings going...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.