• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by extreme-graphics

  1. No Heat SP 300i

    Did you ever solver the heater problem ?
  2. Roland SP-300v Print Heater not working

    The printer started print poor, after looking into it, the print heater had turned to off, but the dried heat was working without problems. I have never touched the heater settings so the machine must have turned itself to off. When setting the heater back to 40c it never heated up at all. I...
  3. Gerber FX rfid sensor

    I have too many edge 2 foils left and wondered if there’s any way to disable the rfid sensor on my FX to avoid it keep asking for compatibility material
  4. Envision 375 Cable wiring pin out help

    Thank you everybody for your help, much appreciated I found a workaround that should keep me going, I accidentally sent the cut file to the enV-375 and it worked perfectly however I’d actually sent the cut file from the GS-15 profile, but it’s worked perfectly hopefully I don’t run into...
  5. Envision 375 Cable wiring pin out help

    Yes the com ports detail are correct in the settings for tenV 375 if I use the GS-15 with the same comport setting com port 3 it cuts on the GS with no problems. It’s only when I send the data to the enV-375 I get the error 23 " unknown plot data " I believe a null modem cable is a crossover cable.
  6. Envision 375 Cable wiring pin out help

    Sorrry it’s an error 23 message I get. Unknown data
  7. Envision 375 Cable wiring pin out help

    Yes I have the settings as per you details and the manual. The GS15 works ok with the genuine 3 pin cable. My guess is a null modem cable db9 to db25 will work, just thought I’d check out if anyone knows the correct pinout before I try.
  8. Envision 375 Cable wiring pin out help

    Ive just brought a backup edge 2 printer and it came with an envision 375 but I did not get any cables with it. Not a problem I thought as I have a GS15+ but I keep getting an error 25 message on the envision, as you can see the GS15 cable only has 3 pins and works perfectly on the GS15, so I...
  9. EnVision 375 (Comm problem) Cable?

    If you still have the cable wiring details that would be great
  10. Gerber Edge 2 Power Supply Blowing after power cut

    Thanks I’ll be sure to get a surge protector from now on.
  11. Gerber Edge 2 Power Supply Blowing after power cut

    Cheers I’ll be sure to discharge them
  12. Gerber Edge 2 Power Supply Blowing after power cut

    I have a Gerber Edge 2, and had the printer turned on, and was just working on the computer getting the file ready to send to the printer When my wife turned a lamp on in the house the bulb blew and it tripped all the power out. When i tried to turn the power back on the printer it would not...
  13. problem printing to Gerber edge from flexisign

    Hi Tom Ok progress report so far, see page 28, ref Using Flexi & Gerber on the same system warp 9 Driver Issue. the driver is actually called par1284. what I learned so far as a default my parallel port was set to LPT3 If I send data to the gerber it prints wit lines across it. if you view the...
  14. problem printing to Gerber edge from flexisign

    The uk distributer has sent me a pdf of how to resolve this problem. They say it's a conflict between the omega software and flexi, I know it's not because I have not yet installed any omega software.
Top