• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by ftfoto

  1. Question S2 160 Opos Cut with Marks 90° rotated

    Recently we ran into a stupid error. we had printed the Reg Marks on the long edge of a graphic. the file was too big to be cut normaly, i did not find a way to tell winplot that i want to cut the graphic but load the material 90° rotated. any ideas if it is at all possible?

  2. Question JFX-200 read out over all printed Area

    thx

  3. Need Help JFX200 UV Lamp Temp High

    indicator shows red, like i said stronger pump does the trick

  4. Question JFX-200 read out over all printed Area

    Hi, is there a way to get a read out of how much area was printed since installation?
  5.

    Need Help JFX-200 Printing surface patterns

    Problem Kinda solved Thanks to Signvinyl for the hints to be sent to our technicians Turns out it was the carriage tunnel where all the tubes are layed in. After several days of trial and error the fix was to put additional empty ink tubes in the tunnel to make it more sturdy i guess. Of...

  6. Question JFX 200, problems with adhesion, formula changed for LH-100 CL

    We observed a change in adhesion in the last two month regarding extruded acrylics. We used to print 1% of LH-100 Clear Ink under our LUS-150 Color Inks as a primer and had really good results. After complaining for quite a time now one of the technicians told us that Mimaki changed something in...

  7. Mimaki JFX200

    had the same problem fixed with exchanging to a non mimaki pump the diameter of the coolant tubes is simply too narrow, they get clogged at the lamps where scale build up happens.

  8. Mimaki JFX-200 LH-100 Ink cracking

    the lh-100 clear ink is the one without flexibility if it is like the lus-100 our tech said it is only meant as a effect rather than full format solid areas. in the jfx-500 the manual is way more detailed http://mimaki.com/archives/034/JFX500_Operation_D202420_V1.4.pdf on page 60 they are...
  9.

    Need Help JFX-200 Printing surface patterns

    Hey there, did anyone come past a similar problem? Talked several times with support and had the tech from japan here no luck, and to be honest communication with mimaki germany is a major disaster right now. banding patterns still prevail. Unidirectional / Bidirektional / ILL / MFD1 no...

  10. Need Help JFX200 UV Lamp Temp High

    Had LAMP TEMP HIGH because a technician didnt use destilled water to mix the cooling solution. pipes and led connections got clogged. pump was to weak to press water through. figured out this was the problem after 7 MONTH! after a long long looooong conversation with technicians we flushed the...
See more
Top