• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Gennalee Thunder

  1. Laser Cut 5.3 Issues!

    Thanks I will look into this!
  2. Laser Cut 5.3 Issues!

    Does anyone else that uses Laser Cut software ever have an error pop up that say communication broken for timeout close and open output window and retry? Then after a few times getting that message it says motioncard softdog no same. Everything was fine till we moved into the new side of our...
  3. Old school sign painting advise

    We print a template and pounce it, line up on your surface then use chalk line powder in a rag to blot against the pounce lines and just fill in the lines, however none have been exterior yet so not sure how that would effect it.
  4. WHAT IS YOUR GO-TO BRAND OF PRINTABLE VINYL?

    99% Of our graphics are in schools and about 80% are new construction so we've looked at the testing kits but it's not always possible for us to test the walls. Basically just being told guess what would be the best material for each surface and we will use it till we have a failure then figure...
  5. WHAT IS YOUR GO-TO BRAND OF PRINTABLE VINYL?

    It's not complete failures say maybe 2 of 20 pieces will fail.
  6. WHAT IS YOUR GO-TO BRAND OF PRINTABLE VINYL?

    We are trying to narrow down our vinyl for wall graphics to around 5-10 different types. We have mainly been using Orajet with Oraguard lams. We've had a couple failures with it and are wanting to try some other brands/types and narrow it down to what we like that way in the proposal stage our...
  7. Need Help Cutting after print need advice!

    We are now making a boundary line around the full section to be cut and adding an inner contour breaking it apart and using the inner contour as our cut file. So far that's been working.
  8. Need Help Cutting after print need advice!

    I've attached a screenshot of a job we are working on each different color is a varying opacity of white. We are having to print and take to our plotter and cut the file after the print is complete our issue is the architect wants it contour cut right up against the design which is almost...
  9. Printing white on Epson S80600

    We tried it and it does work! So thanks!! We were just thrown off by the fact you can set your Spot 1 to say purple and it will read it white wasn't sure if changing the opacity of the purple would be read or just the fact that it is the Spot 1 and just telling the printer this is white. Anyhow...
  10. Printing white on Epson S80600

    We just got this printer and figured the white out however we have a job coming up where they want different opacities of white. The only way we have figured out how to do it is through the printer setting printing one white opacity at a time running it back through the printer and printing over...
Top