• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Gerald Printing

  1. Any one here ever used a Signwarehouse Muse60 plotter?

    DO you or anyone else have problems with the Muse M60 Cutting strip? my keeps popping out of the channel after installing it. i have tried to use a screwdriver, double sided tape and everything but it keeps popping right back out.

  2. Creating FILM POSITIVES on Large Format Printer

    I have a question when using the AccuRip system with our Epson. I am set to print Photo Black Ink only. My printer is saying the "light black" cartridge is low. I don't even use that ink. Is there way to change settings so it only uses the T6531 Photo Black cartridge? Also, where can I get these...

  3. Mimaki CG-160FX Cutter finds marks to contour cut but then doesnt start at center of marks

    Mimaki CG-160FX Cutter finds marks to contour cut but then doesnt start at center of marks

  4. Mimaki CG- 160 FX Cutter Blade not engaging or lowering down to material

    it was the solenoid! we ended up having to get the entire Pen Assembly ($800) and a tech to install it.

  5. Mimaki CG- 160 FX Cutter Blade not engaging or lowering down to material

    My cutter stopped working in the middle of a job. It has never done this before. It still does the program sent to cut the job but the blade is not actually touching the material anymore. The blade does not lower down to cut the sheet so is cutting the program while it is hovering over the...
  6. G

    Printshop

    Printshop
See more
Top