Recent content by Gnomic

Hi In cutting master 4 (CM4) i have enabled "Advance after plot" with x distance. But it doesnt work? Works perfectly in CM3. Maybe it can be set directly in the plotter (fc8600)?

Its the original graphtec bladeholders im using(attached image in #8 - didnt know they made unoriginals that looked like the original)

I wrote with "Clean Cut blade" and they say force should be around 10 or 11 with there blades. (there website: Use 30-50% less downforce). Basicly all of my testing have been with 60degree cc blade. I tryed with a 45degree original graphtec blade, which didnt have problem with the end(left...

- Tryed with clean cut blades 60 blades and the original 45degree graphtec blade. - Other vinyls with the testcut only, with bad/weird results as mentioned in #1 OP. 1. Yes 2. Yes 3. No im afraid not. 1. As you describe a tiny bit of the tip, is sticking out. If pull it bring the blade a...

Did some 120cm wide testcut and the blade is making way more visible in the beginning of the cut(right) and when you get to the end(left) its making less of a mark in the backing. Force 6 - if i use 5, it will have issues to weed. Hard to get a decent image. This was the best i could get. Light...

Thanks for the reply. Yes

Hi I have a Graphtec CE6000-120 with a 60degree cleancut blade, with the following issues: It makes perfect testcuts and if i do a 70cm x 100cm job and starts weeding it, the beginning(or end, not sure which it is) its not problem to weed, but when i get maybe 75% into the weeding, it starts...

Hi Is there any masking tape, which has a backing paper, that will allow me to cut it up in the needed size and ship to the customer? Dont want to ship a whole roll, if i can just give them the needed tapesize. I will in the near future send out wall decals to customers, but i really want to...

Thanks guys. Im going to buy it :-)

Thanks for the reply. So you also have a tape like this? Im a little afraid that this tape is more heavy then paper is, which i see a lot use for applicationtape. (it looks there is no brake on this application roller/holder)

Hi If i get this: App Tape Bench Roller 1349mm, might i have issues Oratape LT95 dropping down into my Oracal 631 design? The application tape should be 122cm(48") x 200cm(79"), to cover the design.

Thanks a lot for your time. Last question, wall decal: have you tryed "Oratape HT55" with "Oracal 631"? if yes, how do you compair HT55 vs 4075-RLA?

Thanks for the quick reply! @bloobird0 No matter if i use little or much pressure, it will have air in between. @ams 1. Just to be sure: So a lot of air in between doesnt matter at all, when i use LT95, since its a "clear transfer tape"? 2. If i used a "transfer paper" instead, would that not...

Hi Im using the Oratape LT95 for my Oracal 631 vinyl, to create wallstickers. When i apply/mask the vinyl, it creates air bubbles quickly. If i let it stay on the table over night, it will look pretty bad: http://cubeupload.com/im/3BCef4.jpg https://www.youtube.com/watch?v=dWXCyC4wZs4...

Thanks a lot :-)