Recent content by Gurupreet Dhanjal

Hi All, I need some urgent advice, i run a vj1614 which has suddenly died, i am sure the mainboard has died, caused by a power spike, I have a vj1204 which we no longer use but i think the mainboard is in good condition, Is it possible to take the vj1204 mainboard and upgrade the firmware to...

Hi henryp, you had advised me on the issue with the printhead slant which I managed to resolve but for the life of me can't figure out how, I am facing the same issue again, could you advise on how I can sort out the slant, secondly on my nozzle checks both black nozzles are firing but only one...

Hi all, I am having an issue with my cjv30-130, one of the magenta nozzles is not firing, the machine was idle for a few weeks and when we powered it up we could not get one of the magenta nozzles to fire, tried everything, cleaning, soaking, pulling through with a syringe. Finally decided...

Hi All, I urgently require firmware vr 2.0 for mimaki cjv30-130, i had a board problem and on replacing the board the new firmware does not recognize the print head. Thanks, G.D

1614 Usb Drivers Hi All. After our tech did some tests it seems the network port has an issue, however everything else works the machine does a test print pallette test and all. i need to know if i can get a usb driver for the 1614 using the onyx postershop 7 rip, i know the usb port is not...

Hi All, Got a major issue, we just replaced the printhead on our vj1614 and now all of a sudden the machine does not communicate with the printer server, our old server crashed so we bought a new one, at first i thought it was a networking issue, but now after trying all kinds of...

Hi we have the same problem, how did you manage to sort it out, Thanks

Hey Guys, Thanks for the replies, i managed to talk to the supplier and after doing some changes on his resetter sent over a new set of chips which work perfectly, @heyskull how do you reset your cards? could you advise me on that as i would prefer to be able to reset them myself rather then...

Hi All, I urgently require firmware for my vj1614, we have been using third party inks for some time now, however my operator recently updated the firmware to 2.0 and now the machine shows "broken chip" on some of the colours, but some of the chips still work. I want to downgrade the firmware...

@henryp, thats exactly what it was, made the adjustment and the machine is as good as gold, thank you sir.

Hi guys i need help on how to calibrate my vj 1614, i have attached a pic of what the problem is, normally i would have looked up my service manual and sorted it out but last month my laptop got stolen along will all my data :-( Long story made short i need to recalibrate the machine and...

Hello, did you manage to sort out the problem, G.D

Hi i am having the same problem where it says Error receivedFNot allowed to write file;0201 i have maintainence engineer vr 1.09, can you help me with the version you used, also the proceess, Thanks a milloin

Hi Guys, Another day another issue, after solving all my problems with the pf encoder CR2 error i finally have managed to get the machine up and running, now i have a problem where the machine is printing black lines across the prints as seen in the picture attached, anyone know why this is...

Update Hi Guys, Well i figured it was the motherboard so i swapped the one on the 1204 and put it on the 1614, after working initiall, it soon developed the same error and blew some components on the main board next to where the pf encoder connector pins are, now that puts me 2 machines out of...