Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ratings hand851 has received

  1. Solventinkjet rated hand851's post Agree in the thread CJV 150-160 CAP Adjustment.

    The adjustment is the plastic stop that the print head carriage hits to lift the cap to meet the head. Mark location with a fine tip...

    Mar 12, 2020
  2. Solventinkjet rated hand851's post Agree in the thread Need Help Vp540 missing Long Clear Plexi cover in front - does this affect dry times?.

    No it does not affect the dryer. If drying is an issue increase dry temperature.

    Feb 5, 2020
  3. BlueMoonATL rated hand851's post Agree in the thread Suggestions Time to update, Latex or Solvent?.

    Compare the two and pick the one that suits your preferences. Solvent I have never had to wear gloves to print or perform standard...

    Jul 22, 2019
  4. Texas_Signmaker rated hand851's post Agree in the thread Need Urgent Help (Roland SP300).

    no it is the heads. The main board is working or you would not get any ink jetting. It's the heads.

    May 26, 2019
  5. jpescobar rated hand851's post Agree in the thread Suggestions Solvent to Latex.

    I would look at a UV printer. No head replacements, no electrician, no bigger AC unit to combat the heat (up side furnace runs less in...

    May 25, 2019
  6. SightLine rated hand851's post Agree in the thread Need help for some unknown tubes on JV33.

    Both hoses are coming off the pump.

    May 25, 2019
  7. Terry01 rated hand851's post Agree in the thread Found ink drain bottle full and overflowing.

    Did you loose ink in cartridges? If yes you left the hose from the pump out of the holder and it siphoned out. It needs to be above cap...

    Feb 5, 2018
  8. Gino rated hand851's post Agree in the thread Printer selection.

    I'd also add the Vanguard flatbed to the list.

    Dec 18, 2017

 


Loading...