I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
anyone know how much material is needed to color change wrap a 2000 club car. I can do an 2000 EZGo TXT on 10' (60" roll). It looks to be the same or less.
Wondering if i can get away with ordering 4 yards over 5.
Thanks,
Roger
Thanks buddy! i greased the tracking up GAC stated too and used fishing reel oil on the tension bearings, between the two it seemed to take care of the noise, it wasnt bad to the point i was like OMG my printer is gonna blow out or something but i do "hear" things all the time, lol
Thanks FatCat, im going to try a little grease in the sealed bearings, i have noticed (what little i have run it) that when i override and run carriage at low speed its not a bad, The noise does run the whole width, but i have had a few moments where the noise dissipates then comes back. The...
Thanks, im going to give that a try first.
Another thing i noticed is that when loading media or using Media Cut the Head travles slower so that seems like why i dont hear the noise.
The Noise did start abruptly....8 inchs into the print it was "normal sounding" and the next pass it had this...
By clean i mean no ink, gunk or dust
its slightly greased but it prob could use a little more, any recommendations on grease i can pick at a hardware store?
Hello folks,
I have a carriage noise when my Mutoh VJ1324 is printing. It started about 8 inchs into a print. The print Quality has not been lost. I suspect it may be a bearing... but when i do a media cut or load media it do not hear it....But when go to CR maintenance i do hear it as it goes...
Profile Help Flexi 12 on Mutoh 1324 - Avery 2923
Need help trying to get Flexi to print on Matte Avery 2923 ez.....Flexi only comes with Avey 1005, and i went to Avery but the file the give me is a Ptf? anyone know how to use this file or have something in a ICC already?
Thanks
I not worried about durability since it would be dedicated to RIP files and their temp and archived files that go along with it. Anyone with experience comparing? any noticeable difference?
Is there any speed advantage to Ripping to a SSD. I use Flex 12 and sometimes Sign Lab 9. I have an extra 128 GB SSD drive sitting around thinking about just dedicating it to ripping.
Thanks,
Roger
Hi, I have just upgraded from Flexi 7 and Signlab 9 to Flexi 12.....I have my Graphtec 7000-130 set to GPGL and communicating but i have to manually change the "scale" to "4" in the plotter menu settings every-time...
I see there is an output size compensation but not able to figure out how to...
are you running the correct profile. It could be media feed too, but your profile also controls the feed of the media and can cause banding. Have you tried another media type?
you cant cut with a VJ1204 or any of the Value Jets, You need a stand alone plotter, like a graptech....needs to have opitcal eye 7000 series or newer i beleive. You also need software that supports print and cut. you can use the Cut Master 2 plug in for illustrator to set up files....repeats...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.