Recent content by Jb1983

HP Latex 315 currently on Nexus_06_03_23.1 When i run the connectivity wizard it fails on steps 8 and 9 8. Gateway Configuration 9. One gateway is reachable Id like to update to the latest firmware, plus every time i start my printer it takes forever because it is trying to send a diagnostics...

So today i downloaded avast antivirus and since then (maybe coincidence) when i go to the CUT tab or PRINT tab to send a job to the production manager flexi print just freezes and i have to go to task manager and end task. its doing it repeatedly i was able to print a job by opening it straight...

Choosing between the GFP 355TH or a Royal Sovereign Fremont 55h. Who has experience with either? was also considering the RS Sigmont 55h

You won’t hVe any problems. You can use cast laminate over calender print film and possibly extend its life but don’t bank on it. cast over calendar = ok Calendar over cast= not ok

I have seen some suppliers listing the Dol 1060z as an option for perforated window graphics. It also states "excellent transparency" in the TDS. Has anyone tired the 1060z for perforated?

agreed, but im pretty sure at least in the past my machines have asked permission to update and not just done it automatically.

Its an HP Latex 315 cutter, my new modem did have a new IP, which is a strange one 10.0.0.221 i am not sure how i can change the ip within the cutters menu? i can change it within flexi menu but that does not work. The printer was much easier to change the ip from the printers menu, and then...

Thanks Old Timer, that worked like a charm for my printer however it doesnt work for my cutter, i even deleted it and reloaded it, when it searches for it finds my old IP, i even manually entered the same ip and port as my printer and it still didnt work. only way i can make it run is by the usb...

I just upgraded our internet to a faster service (same provider) they gave me a new modem to install but now i cant send any jobs from flexi to my hp latex 315 printer or cutter. I get the error " cannot open port"

Thanks for the suggestions. I have 1 switch that plugs directly in to my router and runs my computer,printer and cutter. 2CT Media- How do I setup my printer directly to my computer without the ethernet/network?

Customer dropped off there vehicle with a surprise of having spray painted a few areas with Tremclad Gloss black rust paint. Its "oil based technology" but on the technical info online I looked up it doesn't seem to contain any silicone. anyone put vinyl over this before? ive already put a...

Anyone have experience mixing these two? My supplier does not sell any Avery MATTE laminates, only gloss. I already have a roll of 3m 8520 matte laminate. I figure there both CAST so should not be any issues, plus the 3m laminate has a longer lifespan than the Avery but figured somebody has...

I was unaware this was an option, the tech came and set my printer and cutter up and I was told it must be connected thru an ethernet switch.

Ok, so as far as power management goes even when my computer does go to sleep (4hours untouched) the production manager doesn’t always close. so that’s not my issue. plus I’ve had it close when I’m only 10 minutes in to a print. as for the network connection, I could try a new switch but losing...

I will look in to the cache option, wasn’t aware of this. I never had this issue ever with my Mimaki, with that printer my computer could go to sleep and the print would just pause, and as soon as the computer was touched/woken up it would resume! When production manager closes there’s no way...