Recent content by jdat

haven't bothered cause I know it's the heads that are crapped out or something... Both printers I use myself exclusively are both demo units and ironically they are the machines with the most issues in the shop ... as far as a maintenance contract it's company policy not to have any :rolleyes...

I'd love one myself! the print quality was ok back when I replied in this thread but now I get banding in nearly all the colours when I run an IQ print and my quality has gone to crap. Lately I fill the caps with cleaning fluid and run multiple cleaning+wash printhead cycles .... the amount of...

aren't standard grenadier blades 60 degrees? I'll check tomorrow ... I know it's Roland blades we use

I have ( among other machines ) a contour cut capable Uniform Grenadier machine ( Roland technology based machine that runs eco-solvent for those who don't know ). This is a bit of a generic all brands type question I would imagine. People in the Uk might know these units better than people in...

Let me get this straight: when facing the rear of the machine with the substrate plate in front of you, the caps to the left and the wipers to the right you should be able to access with your fingers the jets to clean under there? Either I'm seeing this the wrong way or there's been a redesign...

does the vinyl you print on have warped/damaged edges? I know 99% of the Glossy Mactac I print on tends to be damaged on the edges of the roll and causes some blobs like you are describing on our 9000s at the beginning of prints and also after after a automated cleaning process. Any more tips...