Recent content by JeffA

Haven't been able to center the cap assy.. Any advice how to? Tried Capping Adjust, but not getting it centered.

Solventinkjet, where do you usually set the Cap Pos., Air Pull Pos., and Flushing Pos. when doing capping assembly alignment. I'm double checking it now. Get Cap Pos aligned more towards center now, want to be sure I've got Air Pull and Flush correct.

Will check damper. They were replaced last winter. Also, didn't even register with me the alignment of the cap. I see that ring. Thanks for pointing that out.

Getting an issue with ink building up behind the head unit on our Mimaki CJV150-130. The ink pictured is fresh immediately after a test print that was done after cleaning the head and the area around it. Currently I have the foam pads that are usually on the capping station frame removed. But...

I am getting this exact problem with our wrap on Avery 1105 (on a Mimaki CJV150). It's heavy on black and am getting the same picking you mentioned.. Did you ever resolve this??

No, CMYK SS21.. 8 cartridge

You reference a bag, and I'm realizing that you are refering to the bulk ink system, which I don't use. Use ink straight from cartridge. So, I'm less understanding why the notice of the change came up.

I've seen that part as the only connection to the issue, and your reply confirms that is the part. That is good info. Thanks. Do you know of any write up on the replacement process?

Have a Mimaki CJV 150-130. Got a message this morning to 'replace the spout rubber of eco-cartridges'. The user manual shows nothing more than that it needs to be replaced but of course gives no details about the part(s) or process. I know where I can reset the counter for the message but...

Printing on Avery MPI 1105 Supercast Easy Apply vinyl and am getting waves of lighter shade in the print (including pic). Using a Mimaki CJV 150-130 Running with temp of 40/45/45, low pinch roller pressure (due to thinness of material), the Avery profile matching the material, 720x1440...

Checked that idea this morning. The sort function is in the option box and works independently of the cut path box. Tried what you suggested and didn't work. Sort would be in same condition for either path.

Using Rasterlink6 and printing with a Mimaki CJV150-130. We are printing stickers with two cuts, a half-cut square around a kiss cut image. The order we want it to cut is the kiss cut first, then the half-cut. Using the Mimaki Fine Cut tools in Illustrator we designate the kiss cut path...