I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I struggled with one clients vans. They pretty much use older econoline vans with the small body groove so all different brands of vinyl shouldn't matter. It kept lifting in those areas and I kept redoing them. I switched from 3m at the time to Avery and tried Arlon as well and kept gettin the...
So when I print in Bi-directional I get the random blue print. When I print uni-directionally I have no print issues.
That tells me it is printing on the right to left pass ok and when it prints left to right I have the issues.
Any Takers??
Cleaned encoder strip a few more times, checked cables.
Still have the issue in the same area on the material.
but then I print a 20' long camo pattern that takes up most of the width and not a mark anywhere.
The mark is always only blue.
The past few days I have noticed strange blue vertical running lines that vary in width through the middle
of prints. Usually it only prints them on a colored background and not so much on the white background.
They are always blue and in the same area horizontally. I assumed it must be the...
I too have been having a difficult time with 3m the last couple years and finally switched over to Avery. I started having call backs with simple shallow grooves coming up after a few months. I did one particular van 3 times with failures in the same spots. I switched to Avery and the issues...
Thank you for your reply! I’ve tried all the ports on the rear as well as front of computer to no avail.
Thank you very much for your reply.
I have tried every port on computer front and back and it seems not to matter.
I have the same degree of success.
I just figured it out and tried it.
now that I know that the lights aren't supported by versaworks, I was able to successfully calibrate it and get to the measure part. When I click measure
and then click on the side of the instrument and proceed across the first row, it gives me a 4087 code...
Thank you for the reply, yes I have done that. I have pretty much watched all the videos and tutorials from versaworks I can find. Can’t figure out what I am missing? Obviously I am missing something though. I’ve uninstalled and reinstalled the drivers several times as well. But know it can’t...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.