Recent content by JM4Designs

Windows 7... As far as I can tell there weren't any updates when this started.

Curious if you ever got this resolved... Just started getting this error message from Rasterlink seemingly randomly, but very frequently. I have reinstalled Rasterlink and the printer drivers twice now and the issue persists.

Just started getting this error in Rasterlink: "PS Interpreter Panic Error - Error occurred before errordict setup. Check your init files" Sometimes it does it while reading a file from the hot folder, sometimes while ripping to the printer. When it does it I have to shut Rasterlink down and...

It's white acrylic, but my main issue is the perspective, or whatever distortion that's going on with the photo that makes my vector innaccurate. Thanks for the input!

We're redoing acrylic trim cap faces for a chain of stores that were made by someone else, and the faces are an odd shape. Mostly a circle, but with other flourishes coming off the circle. Our process thus far has been: Get a rubbing of the existing face, hand cut new face. This is where it gets...

I also do these 2 things. The print can be straight as an arrow running through, and as I watch from the back of the printer it's right on track to hit that 1st rear mark, then it just gives up. I think we just have a lazy printer.

Thanks for the reply. I'm using the recommended size, which is usually 1.37" on anything bigger than 10 foot. Anything over about 15 foot run, it will read the front two reg marks, but stops an inch or two short of reading the first rear reg mark, then gives an Error 36 mark detect. I have the...

I know this is a really old post, but did you ever come up with a solution? I'm having the same issue with anything over around 15' long. Right now my workaround is to have 2 separate sets of registration marks so I'm basically cutting twice, in 2 halves. Hopefully you get this!

Nope. Still the same problem. I've collected a whole bunch of other ICC profiles and some come out less red/pinkish. Still off though. I just don't understand how I can have this problem on our JV150 but our CJV30 which sits right next to it does just fine with the built in profiles...

Test prints are fine, and I've tried profiles from all of our media manufacturers, 3m, Orajet, etc. All seem to have the same issue. If it were an issue of profiles being made in a different place, then I would assume our CJV30 would have the same issue, but it does not.

I recently took over running the printers at work, the CJV30 is pretty accurate color-wise, but our JV150 is printing way too reddish. An orange warning sign I just printed needed the magenta pulled back in the art about 15%. Photos of people come out looking sunburnt. Doesn't matter what...

Hi all, new here! So I've had a reoccurring issue where after printing and laminating a run, I load it back in the CJV30, find the first registration mark, then send the cut file to the printer. (Both printing & cutting are sent as a hybrid job from CorelDraw through Rasterlink.) Once it goes to...