• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by JRgraphics

  1. Oh no!! No serial port after new motherboard. Only usb's.

    Can you give us the model number on the motherboard? Even the new ones have ports along the edge that are legacy ports (com, serial + others). It may take a cable to get it to the back of the computer, but it is worth a look.
  2. improving cut quality on an envision 375?

    How to cut difficult material on the Gerber Envision 375 I would move the blade back in to the holder so very little is showing (you want to scribe a line). Once the lexan is scored (scribed), reset the blade and depth. The blade should follow the scribe line for the final cut thru. Make sure...
  3. Gerber Edge II Extension Cord?

    Extend the USB side of the cable.:smile:
  4. dull streaks in Edge 2 prints

    I forgot to say they break, worth the check though.
  5. dull streaks in Edge 2 prints

    Look at the ground straps, especially the one between the top and bottom halves of the clam shell. It could cause streaking.:thumb:
  6. omega 6

    Information needed about Omega 6 Hi all, I like the fact that Gerber has not left us behind by offering the new upgrade. If anyone gets this installed, please let us know if it is worth doing. From reading the list of new and improvements, I notice that most of the upgrades are fixes and simple...
  7. Omega 6.0 will it happen?

    Well for one, I'd like to see the software updated to 64 bit.
  8. Omega 6.0 will it happen?

    It would be great to have a new version of Omega soon.:thumb:
  9. Foil sticking to print head?

    Gerber foil clutches are expensive Hi Fred, I talked to Gerber yesterday, the cost for the 2 clutches was $554.00 plus shipping. The LE is 15 years old, I'm going to think it over. JR.
  10. Foil sticking to print head?

    Hi Fred, thank you for answering. This just started yesterday, all of the foils that I have tried to print, black, process black, white have all stopped. Do you know how much the clutches or clutch motor costs to replace? Thank you, JR.
  11. Foil sticking to print head?

    Gerber LE printer Gerber foil advances 2 to 3 inches then burns thru. ?
  12. Covers

    Patio furniture covers work Hi Jake, I found covers for the Envision 375 at the local home improvement store. Look at patio furniture covers and barbeque covers.
  13. gerber edge and shop cleanliness

    Not all vinyl.... Sorry to say, I learned the hard way. Gerber 220 clear enamel receptive vinyl will be ruined by wiping down with isopropyl alcohol (it takes the receptive coating off and leaves a mark on the vinyl).
  14. Long Run on the Edge...

    What Edge model are you using? What program are you using to print with? If you are using Omega, what version is it?
  15. New 'puter for edge/envision- com port problems

    Buy a serial card Buy a add on serial card that fits an expansion slot on your computer. They are easy to find and set up.
Top