Recent content by Kenny

Since the image is not completely cut, check the EPS Margin setting. The default is "0", which can cause the incomplete cut you are describing. In the Versaworks window, top menu bar, select Edit, Queue A Settings, go down and click on File Format & look at the EPS Margin setting at the top...

Request the kit now...you'll need it on 30" rolls of laminate, or as the 54" rolls get low on the roll.

Don't forget the laminator...

If the original designs were created in Autocad, you can open the file with Autocad and combine the line segments into a closed polyline with "0" line width. Then, export as DXF, import into Flexi, and most should come in grouped correctly. Some may require a few tweaks, but this is how I do...

Perfect...Thanks!

Anyone know this one? (from a Hello Gorgeous salon logo) What the font shows "Portia" as a close match, but need something thicker.

Check the "Print Quality" setting in your media profile. It's prabably changed to "High".

Basic Sans Heavy is close..."t" doesn't have the slant at the top, though.

Welcome to the forum, neighbor.

Left mine from Monday of last week to Sunday...no issues. Just do a maintenance cleaning before you leave and you are good to go. Also, what was said about about leaving the main power switch "On" so it cycles the print heads.

So, come January 1st, when suppliers "adjust" material pricing, you keep your pricing the same?

Ebay

The Distort you want is "Arc-top"...apply it and right below the image in the DesignCentral dialog you can mirror the effect to be top or bottom.

If you can get into service mode, I'd also take a look at the shot count on the heads...replacement is recommended at 6-billion. 2-1/2 yrs, you may be close. On the captops, there is a sponge at the bottom to help wick the ink down into the drain tube. Sometimes the sponge can swell up and...

When was the last time you replaced the captops? Wipers? The cross contamination points to the captops, the misalignment could be partly from dirty wipers.