• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Michael Hajduk

  1. Vs-540i cyan not printing but printing in pink band

    Yes the head had to be replaced and now all is fine, the white line seems to be a bad choice with this ink setup. Not used enough and then dries out and damages print head. Have replace the white line and now only filled with flush fluid for the white before changing printhead. Also found...

  2. Need Help Is my head gone?

    A good way to test the dampers is to leave the ink lines on and pop the side clips on the printhead and separate all four dampers from the printhead by pulling up. Make sure you turn the printer off for this test, this will close the choke and stop ink from flowing. Just don't turn the...

  3. Changed Printhead on VS-540i

    Print head was passing ink between white and light magenta, wasted a lot of ink to figure this our and test prints were not good. Finally ordered a replacement DX6 printhead from amazon from wholesalesignshop and they shipped it to me from china in two days. Brand new roland box with head...

  4. Vs-540i cyan not printing but printing in pink band

    New to this site and have a problem with my printer not printing cyan, I think lite cyan. Only about 1% of nozzles on print test. When I do a lot of cleanings the cyan slowly comes back but after a printing a small graphic falls out again. When it falls out it starts printing a full color...
See more
Top