I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi!
Thank you for the input! I will bump up the dryer too. I do have 6 clogged nozzles I can't get cleaned out if you have any suggestions for that, I manually clean weekly. About a 3 month ago I had a dampener sensor go bad and it dumped out a good amount of cyan ink on the print. I replaced...
I just ran my first job with just the 2 rollers on 54" material, it was just a few stickers, but so far so good and no 5 minute wait time to dry, thank you!
Thank you, I will double-check that as well. I downloaded the profile for the 3m material from the roland site, and thought I selected the tr2 ink, but I could have selected wrong, I will give hat a try
Last week I finally ran out of my TR Roland inks and switched to the TR2 inks, but now I am getting roller tracks when I oo a print cut that I did not get before.
I am using the same material and loaded in the same profile that I had been using and reprinting some of the same prints. Now when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.