Recent content by NP_18

We cut stencils out of paper with our Summa. Just use a dashed cut contour or flex cut

Where are yall getting the vhb dual lock in just the hook or loop? Everywhere I check it seems to be full sets of hook and loop only. EDIT: I see now.. both sides are the same.

:) Yep. These will be going around the inside perimeter of a stadium. This is supposedly a common thing among stadiums (I am told).

Have you ever installed a banner with velcro outdoors? What would be the best velcro to use in this situation? Banners will probably be around 50' x 5' with a 2" velcro (loop) sewed around the perimeter. Velcro (hook) will need to adhere to a smooth concrete/brick wall, outdoors, and last 4-6...

Below link is usually my first go to when looking for fonts. https://www.whatfontis.com/?s2o

Rosemary

I have never made these, but according to eyeblackstickers.com they use "3M medical grade tape (latex free)". Maybe one of your local vinyl reps can point you in the right direction.

I like the PVC route. Can get some 1/2" green pvc pipe for the stem. I never considered just getting plastic leaves that's a good idea.

They are set on Daffodils for now unfortunately, maybe I can convince them otherwise..

Have a client looking to do something very similar to the attached pictures. They want a few hundred flowers made and for them to last long term. I was thinking go metal and weld/paint, but wasn't sure if there was a better option? How would you go about it?

Material will not roll back onto the core as it cuts, but it will allow you to start with everything as straight as possible. We run tens of thousands of 2" x 2" decals and our alignment issues completely disappeared after we started keeping the material on a core and using the flanges/guides.

Is the printed material on a core and are you using the media flanges?

I just have the one picture, but when asked they said that from the side it looks like it has multiple layers. Thanks for the advice!

I have a client with a several of these room ID plaques in their building and they want to add more, but I can't find this particular one anywhere online. Any idea where I could get one or who makes them? The black section is open and allows a slip of paper to slide in from the edge.

I didn't think there would be enough surface area on the exterior screen to print or paint and the image be recognizable. Openings are about 1" x 2" and wire cross section maybe 1/6" thick.