Recent content by OKC Fabric Printing

Well, I've gotten the tube bridges removed and the caps put on the respective lines. In the printer's menu and in Rasterlink properties I dont see any options for changing to the updated inks. I ordered them and they have not yet arrived. my local tech is very difficult to communicate with. Any...

Thanks, i'm waiting on my local tech to get back to me.

Thanks! yeah thats right i do recall there being a tube bridge on the first group and second group. As far as the software, do i just insert the new chip and it automatically does its own thing or does there need to be a firmware update?

Hey there, I have a Mimaki TS300p-1800 setup to print SB411 inks. Dye Sublimation, anyhow the printer is setup with 6 colors of ink, even though it has 8 slots. The first two are Magenta, next two are Blue, then Yellow, Black. Light Blue and Light Magenta. What i'd like to do is have the...

Hey there, I have a Mimaki TS300p-1800 setup to print SB411 inks. Dye Sublimation, anyhow the printer is setup with 6 colors of ink, even though it has 8 slots. The first two are Magenta, next two are Blue, then Yellow, Black. Light Blue and Light Magenta. What i'd like to do is have the...

Thanks!

Hey i'm using rasterlink6 v5.16 I really hate running out of paper in the middle of a print, i'm sure no one likes it. Is there any way to tell the software, hey i've just loaded a new roll of paper, it has X amount of feet.. so it knows when you're nearing the end and stops you?

Thanks. I'll check them out

So I am looking for a resource where to find design blanks like the one below for clothing that I can then modify to my own needs. I'm looking for the blank design of the t-shirt and other clothing patterns that I can then plug into my PS and make my own deigns. Any suggestions?? Also, are...

I'm running a Mimaki ts300p-1800 for dye sublimation and running Rasterlink6 V5.16 When printing and the paper roll runs out. I have to lift the front cover and raise the presser feet to swap out rolls. Then the printer needs to check the paper width. The problem i'm having is with...

yup, i've decided to go ahead and replace two of my heads. I've already replaced two pumps and all 4 capping stations. Thanks!

Thanks!

I've tried to do some searching but havent gotten any results as to which chemicals and what ratios. would you happen to have any links to such info?

speaking of homebrew. any suggestions on where i can purchase any cleaning fluid cheaper than mimaki?

Thanks, yeah i can swing the 7k just wasnt sure if it was worth it. But you do make a great point. these machines are from what i've been reading built really well and now that i've opened it up quite a few times i'm pretty familiar with its internals so i could make small repairs on my own...