Recent content by oldcaliprinting

That did it. Thanks so much

Had some issues with nozzle check not 100%, had to pull the head and flushed with some air. Got it back to 100 but now I get a magenta line under my blacks. Nozzle check looks good. Wondering if its some sort of alignment issue?

Couple of things I tried. Soaked the head overnight. No change in quality. Purchased a set of blank cartridges. Filled with Jteck cleaning solution on the two magenta lines. Ran a full charge, let sit overnight. Ran another full charge the next day noticed the print on the nozzle was fading...

Mutoh 1628x Sublimation Jtek inks Started getting weird results on one of the magenta nozzle. More of a dotted line. The result is my reds are not printing crisp. Soaked the print head in solution over the weekend and it seemed to come back to normal. Threw a small job and went back to...

Have you tried a small charge? If so, remove the damper and pull ink through the damper with a syringe and then a small charge. It sounds like air is in the line.

If anyone can help me out with a service manual I can use one as well ocscreenprinting@gmail.com TIA

Got er running!!! Thanks to the guys at Solvent Inkjet for all the support. They recommended pulling out the memory stick, blowing some compressed air. Came right back up. Did a little charge and boom 100% nozzle. Beef Jerky time.

Took the board to the local cellphone repair since I didnt have the tools. Tested ok, wired the board back up and now I just get Red lights and no power to the display. Reading from left to right 2 reds 2 blank the rest red. Also, LD1 is red, and I get an LD1 flashing red on the next board over...

Thanks for the info. So the fuse would cause the nozzles to not fire even though I am getting no errors now?

Just installed a new printhead on a Mutoh 1204, the first time I installed the head I received the dreaded e075err head cable error. I swapped out print head cables but these were longer than the original. I was able to clear the error. Now the issue seems that I can not get any color to fire...