• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by osmasterflex

  1. Creating Gang Runs in InDesign

    Big Dawg, Can i email you a PDF i created. Check it out and let me know if im even close to what should happen. Its just a test setup. Its a Gang Run Print, so there will be multiple differnt flyers on there, so the edge colors WILL NOT be the same. Thats why they require a .25" bleed...
  2. Creating Gang Runs in InDesign

    1 " bleed on all edges, so the workable area is 28" x 39" It will just be loaded with 4x6 Flyers. Setup at 4.25 x 6.25, Setup Butt to Butt, Bleed setup for cutting, finished size is 4x6. a .25" gutter/slug in the middle of the sheet.
  3. Creating Gang Runs in InDesign

    Is anybody here familiar with setting up Gang Runs in Indesign? I've been asked to see if i can setup a gang run, on a 28" x 40" sheet. I was thinking it can be done in InDesign. Are there any specific requirements with setting up the file, and for exporting it?
  4. Cant name this font!

    Help me with this pleaaaase
  5. font

    font

  6. XC-540 & Media VERY STRETCHY after print

    Let it dry for a day...I had the same issue before with the same printer, and after letting it dry for a day it was a lot better.... The media is still warm from the heater.
  7. Versaworks

    Well its most likely the part of the image with the drop shadow, so remove the CutContour stroke completely. Then click on the image that needs to be flattened, and go to Object then Flatten Transparencies... Then go back and see if you can put the stroke around the image.
  8. Versaworks

    make sure you flatten transparencies...When you save the file, did it show some sort of error about Transparencies?
  9. Roland Soljet Pro III Black Problem...

    Dont use RGB to print. Set your files up with CMYK
  10. store

    store

    store
  11. Member Album by osmasterflex

    Member Album by osmasterflex

  12. van1

    van1

  13. Illustrator to versaworks issue

    can you email me the file? sbashir@snapgraphics.com
  14. Illustrator to versaworks issue

    He states, he drew the contour on his face when he brings it into illustrator, and only HIS NAME shows. Just import the picture into illustrator, and type all the text in illustrator as well. select the text, put the contour cut on them, then draw around the picture. Keep all the contour cuts...
  15. Illustrator to versaworks issue

    Are all the counter cut lines on the same layer? Is the image of them, and the contour lines on two differnt layers.
Top