• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by PhatWall

  1. valuejet1604

    could be an issue with your media
  2. VJ-1204 Ink Smart Card, Chip fix

    I got ya covered www.truesolvent.com
  3. VJ 1204 chip card

    Check out my store go to www.truesolvent.com I can help you with your 3rd party ink as well as CIS systems
  4. Mutoh 1614 firmware downgrade

    I can help!! call me @ 307-252-7333
  5. Mutoh tech contact info needed

    tech here I live in wyoming but can always fly what is the problem
  6. VJ-1604 card issues

    fw i am running 1.13 and was working fine before.
  7. VJ-1604 card issues

    I have a mutoh vj-1604 and i just got done printing a banner. I switched material abd when i put down the blue load lever the material would not initialize the size. It just said initializing so I switched of the power and rebooted the printer and have a new problem. First of all I use 3rd...
  8. Design for a Artic Cat M8 Snow Mobile

    That is funny lol, I will try to add a better pic.
  9. Design for a Artic Cat M8 Snow Mobile

    Please let me know what you think about this design for a Arctic Cat M8!!!
  10. Mutoh VJ-1604 Error Code

    try this one and this might help. In the picture the motor that is labeled #1 may be at a weird angle causing that belt to crawl. when this belt crawls it walks toward the encoder wheel and jams causing the E074 error. First off find out which way the belt is walking and compensate for the...
  11. E074Err CR2 Current-Error

    try this one and this might help. In the picture the motor that is labeled #1 may be at a weird angle causing that belt to crawl. when this belt crawls it walks toward the encoder wheel and jams causing the E074 error. First off find out which way the belt is walking and compensate for the...
  12. E074 error answer 2

    try this one and this might help. In the picture the motor that is labeled #1 may be at a weird angle causing that belt to crawl. when this belt crawls it walks toward the encoder wheel and jams causing the E074 error. First off find out which way the belt is walking and compensate for the...
  13. Dropping prints

    try removing your printer from your rip and reinstalling your printer in the rip software
  14. Mutoh ValueJet 1614; Replacing Capping Station

    i did this last week. Open up your cover to access the maintenance station. Once in there remove the two screws on the right side of your maintenance station that holds the capping station. lift on the right side and remove the plastic holder that holds your station. from here you should...
  15. E074 error answer

    try cleaning your steel belt line that your print head is connected to. I believe this was my problem when I had that error. today I changed my maintenance station, my printhead about six months ago, and my encoder wheel 4 months ago. If anyone has to replace any parts I highly recomend...
Top