• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Ppcwilly

  1. Mutoh 1204 Media initialize

    Thanks for your help:)
  2. Mutoh 1204 Media initialize

    The media moves forward and backward before printing. Is there a setting to change this. Thanks Bill
  3. Need Help Mutoh 1304

    Question do I need to input my head rank info from the new head. Some have said it does not matter, will that have an impact on my print quality? Thanks
  4. Need Help Mutoh 1304

    Hey Jim, Thanks adjusting my media feed seems to have worked.
  5. Need Help Mutoh 1304

    Here is the latest print, it is 100 K black.
  6. Need Help Mutoh 1304

    I cleaned both the pf and cr sensor and encoder wheel, no change. Thanks for your input!
  7. Need Help Mutoh 1304

    Is this found in the media setup menu?
  8. Need Help Mutoh 1304

    I had ordered a generic one awhile back for my 1204 and never needed it, The 1304 T-fence had some spots that would not clean off, so I put the generic encoder in. That made no difference in the print. The printer was really dirty, took it apart and clean everything. Recently I purchased a...
  9. Need Help Mutoh 1304

    I tried some 3651 and Some fellers vinyl, same results. These substrates printed on my 1204. After the alignment of the head it printed a little better. Printing at 720x720 8 pass with high ink flow it looks better, but you can still see the vertical lines or shapes? Could it be the board or...
  10. Need Help Mutoh 1304

    Yes I finished do all the head alignments, prints the same!
  11. Need Help Mutoh 1304

    The nozzle checks look good on all colors. I have the service manual can you give me the specific section you are referring to for head alignments. Just want to make sure. Thanks
  12. Need Help Mutoh 1304

    I recently got a used 1304 to upgrade from my 1204 in order to print 54" media. I have replaced the T-fence ,Printhead, MS . Also have thoroughly cleaned the encoder and raceway bearings. I am getting lines in the print that show up on all colors but are more evident when printing black. Any...
  13. What the actual &%$# is Corel playing at?

    This happened to me I emailed and they sent me this response, it worked. Then delete Corel's messages folder. Steps to delete the files in the messages folder. 1. Close all programs 2. Click on the start button 3. Go to the search box and type Run 4. Click on the Run program. 5. In the Open...
  14. 16 oz freedom banner material

    Can cut vinyl be applied to this or is it only for printing?
  15. 16 oz freedom banner material

    Fellers used to sell the 16oz and 18oz freedom banner material double sided with blockout. I have have some left over but am looking to buy some more soon, does anyone know of a supplier that sells similar material for cut vinyl. Thanks
Top