• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by FTG

  1. Black Nozzle Dropout

    No it wasn't replaced the printhead and maintenance station and it was printing great. Started to lose black that's when I replaced dampers, o-rings and nuts.
  2. Black Nozzle Dropout

    O rings are brand new. I didn't notice a crack while looking it over but it won't hurt to check again, I suppose. Thanks
  3. Black Nozzle Dropout

    My black nozzles keep fluctuating wildly between cleanings. Printer has new dampers and o rings, new cap top on the maintenance station also new print head, cables and maintenance station within the last few months. I can't seem to figure out what is causing this. There is ink flowing through...
  4. Mutoh 1204 Printhead Issue

    Sorry forgot to get back on here. I just removed the dampers and pulled ink through the lines with a syringe. Must have been air in the line somewhere I couldn't see it or maybe the damper just wasn't seated on the head correctly. Sent from my iPhone using Tapatalk
  5. Mutoh 1204 Printhead Issue

    Resolved the issue thanks everyone.
  6. Mutoh 1204 Printhead Issue

    A couple months ago I started losing black nozzles on my printer after a few head soaks and cleanings it was back to normal. It worked great for one print then just started dropping nozzles like crazy immediately afterwards. Ended up replacing the capping station, printhead, dampers and print...
  7. Here's one to make ya laugh

    Where we're located in SD they ran a radio ad about every 30 minutes about distracting driving that included a bunch of blaring noises (cellphones, kids screaming, sirens, etc.) and every time this obnoxious commercial would come on I would find myself looking around everywhere and slowing down...
  8. Font Help

    Could've swore I knew this, or had it on my computer but I'm striking out looking and on other identification websites.
  9. Opinion on Arlon Wrap Material

    Just finished up a partial pickup wrap with it and worked great. I'm with the majority here though, great for partials, trailers and other flat surfaces but way too much initial tack for full wraps.
  10. Font or Drawn?

    Pompadour numerals maybe?
  11. Font ID

    Anyone know the "Dirt Track" font? Thanks
  12. Franks face on a fellers warehouse now...where next?

    Turns out this is how you become Fellers Certified.
  13. Font Help

    Anyone know what font the "Mike's" is?
  14. Thoughts on what's causing this?

    We run a Valuejet 1204 and have started to get this problem, I think it may be called "cockling" or something like that, thought it would be from the heat settings set too high, the heat is set on recommended settings so I bumped everything down 5 degrees and we were still getting the problem...
  15. My Logo

    The Red Green Show! Hahaha
Top