I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Here is a better picture of what's going on
I am getting ready to do the head alignment tomorrow. Did all the test prints and got all my notes and adjustments ready..
Oh ya, I'm familiar with the head height of high or low in the menu when setting print option.
So there is no actual adjust for head height? It's either high or low. Confusing because I got the message that my head height is too high when Its always set on low
Ok, got a little bit better today
I was able to print the test for bi-directional and horizontal , horizontal was off by 7 points but after the test it gave me a message that said SET HEAD HEIGHT TO HIGH? Your help is greatly appreciated
Oh, thank you
I did not see that picture
Apparently I don't have the correct procedure for head alignment? Step 1 is.
Service menu
Head adjust
Then head adjust bias
Bias test print
I don't have that
I do have the procedure to do the head alignment
I believe there is 3 separate tests and adjustments
I really just want to print the test to see if it's off
I been fighting this problem for over 2 years and the machine is only 5 years old
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.