I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Yes Mike, he DID cut them the same as the letter backs! NOW, would you think that the existing faces could be "trimmed" enough to make this work, or would you scrap them? I was asked if the warping would be permanent at this point, and I don't think I can truthfully answer.
Thank Again
Thought I sent this response a minute ago, but did not........................our channel letter guy along with our shop foreman just informed us that they riveted the faces to the f trim about every 6". To me, therein lies the problem. No room for expansion/contraction!!
I will get some photos, but I will say that we have been making channel letters for over 30 years and have never seen this problem. But there is always something different.
In your experience, with say 6 to 10' letters, if you used an f channel trim cap, would you allow for any...
We have made two sets of 6' Blue faces, and both times with two different materials, the faces start warping.
The guys are using F-channel for the retainers. A day or two after the installation they were perfectly flat, but now after a couple of weeks, we get a photo yesterday (and I went and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.