• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by RippinPC

  1. Epson Service Program Needed Please!

    Thank you!

  2. Epson Service Program Needed Please!

    Need to empty inks to swap circulation pump on SureColor S70670 and need that program to prevent a big mess. I'll happily return a favor. Chris

  3. Service Manual for Value Cut VC-1300

    I was able to obtain the information I need from the user manual. Thanks anyway. Love Signs101. Chris

  4. Service Manual for Value Cut VC-1300

    Looking for a service manual for ValueCut VC-1300. GCC Jaguar IV equivalent if the service menus and calibration are he same?rippinpc@yahoo.com

  5. Tech needs printing supplies to teach my son

    I've been a tech for years now and haven't had to buy materials, inks, etc. Not sure who is best to buy from. My second oldest son just graduated HS and wants to learn my trade. I was able to obtain a Mimaki JV3-75SP2 and CG-75ML cutter. We setup a PC and got everything connected. Now we...

  6. Service manual for a VJ 1204, 1304 or 1604?

    Need 1614 manual Can someone please email me VJ1614 manual? Chris rippinpc@yahoo.com

  7. Mutoh Maintenance Manual

    Can someone please send me a manual for ValueJet 1304? RippinPC@yahoo.com.
  8.

    JV3 160 Print Issues

    Have you replaced your capping station? I would ensure the bottom of the head is clean and the cap is clean to ensure good contact/seal. A small air leak would partially clog the head until if pushes enough out to clean itself. If it wasn't that, I would follow the advice above about...

  9. Optimal PC setup

    I'm looking for information on how Signlab works. I emailed their tech support earlier today and hope they answer as well. Can SignLab utilize a scratch disk? Does Signlab run faster on it's own drive? Any tips or tweaks floating around to optimize setup? Thanks,

  10. Changing dampers, pump and print head question

    Did they ever print the same?

  11. new ink cartridge printer says its near end??

    If it is just saying near end, don't worry about it or you don't have to worry about it. It will wait until the cartridge is almost empty and then hit the 'ink end' switch. It could be a faulty chip on the cartridge.
  12.

    Mimaki JV3 - Never seen this before!!! HELP!

    If your screens keep popping out you have a problem. Cleaning, alignment, etc. This is a very risky/expensive situation as it can easily scratch the bottom of the heads.

  13. What Can I do with a Non working JV3???

    Send me a message and we can talk about your options.

  14. jv33 printhead not genuine

    I'd be surprised if you could upgrade the f/w after that and it still work. I would expect the error to return as soon as you upgraded. This assumes that the old firmware will work with the head that you have installed.

  15. Mimaki JV5 Banner Material Warping Problem

    It could be many things. The JV5 feeds media so fast compared to JV3/33. It could be your roll isn't feeding straight. It could be that your material is sticking to the metal feed path (metal that gets hot when the heaters are on). All Mimaki's can be set to C or F for heat. Either way...
See more
Top