I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
3 weeks is nothing. It should flow just fine if that's all it was. Put some cleaning solution in the cap and let the head sit there for a few hours. Then take 2 syringes and plug them into the waste hoses. Clamp one hose with forceps. Then push the head and hold as far right so the cap is...
I run a couple of 1204's and one keeps getting a write port error. Both run on same network, routers, and flexi yet one has no issues and one will print 3-10 inches then gets a write port error. Been working on this for like a month and still scratching my head.
I have tried running a direct...
Network is working great. Prints every time, however my prints suck. I get lines, white spots and jagged edges. Of course I just been blowing thru junk vinyl figuring this thing out. It's probably the vinyl. Been cleaning the head off as directed and also been cleaning off the vinyl off...
Figure since I could never find a solution and only people talking about the Gerber cable, I figure I would post my solution. Picked up an old Edge 2 for cheap to just do some chrome stuff and the whole usb to parallel thing seemed ridiculous. The guy I bought it from gave me the actual Gerber...
There is a little plastic connector that the clean out tubes hook to. Shaped like and H in the maintenance station below the cap. That thing always plugs because the holes are tiny compared to the tubes.
Anyone know how to turn off the grommet question before printing, driving me nuts. I don't use grommet material nor ever plan to. I have to go into the printer room every time to hit the buttom and it's erking me.
Sign warehouse has serious customer service issues. Tried dealing with them this morning and unless you pay for the tech support package you will not get any help from them. Spend a shit ton of money on a cutter and they can not even support it. No sure how they stay in business, I guess a...
You need to find a trial version of flexi 12. Go through the driver list and find the 1204. Then you need to copy it and rename with correct driver extension for 7.7 then put in the output driver folder in 7.7. Once you do this it will show up in the PM to add as new printer. is does have a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.