• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by S2S

  1. CLEAR ACRYLIC WITH CLEAR DOUBLE SIDE # application error#HELP ME!

    Not familiar with spicers that you mention...I am not concerned with the white laminate adhesive as much as the adhesive of the clear. In my experience...I had some "water-based" adhesive that had this same issue. I would check specs on the adhesive that is on the clear. Make sure that it is a...
  2. CLEAR ACRYLIC WITH CLEAR DOUBLE SIDE # application error#HELP ME!

    What clear vinyl did you use What white vinyl did you use
  3. HP Latex 570 Error 19.12:10 - Help

    Only changed the bad one...used Multi Meter...plus there are led lights that were not on so it was obvious which one was bad...
  4. HP Latex 570 Error 19.12:10 - Help

    Grabbed a replacement thru digital media warehouse...spoke with Phil first, very informative. Also spoke with Brendon for processing order. I picked up this part from them...changed out curing unit for this same error, back to printing. The service and knowledge from them was top notch.
  5. So, I Joined the Summa Cult... New Acquisition S120 T Series

    Got a t160 usb dont need...we needed ethernet..got new one to compensate...
  6. General Formulation’s cheap 54” matte better than Oracal 3640

    201 for calenderd for indoor never outdoor...their new cast films for outdoor..although we use 3M 180 consistently for outdoor
  7. General Formulation’s cheap 54” matte better than Oracal 3640

    Oracle liners are way to thin!!!!!..been that way for years hence why we do not use the films....step up oracal, Get on board...however you want to put it. Tried them...Curls on every product
  8. Need recommendation for entry level flatbed cutter

    Colex. You we wont be sorry.
  9. printing grey and getting red/blue/green undertones

    Metamerism...color profiling for gray balance helps
  10. Summa S2 T140 oposX cut on holographic vinyl???

    I agree..done that as well...it works... Also if gloss laminated use the finest grit steel wool and rub all reg marks
  11. Mutoh XpertJet 1641SR – Media cockling!

    I have 3 1624x...1 1604 before...out of service now...no problems...but mutoh..if your listening...this should be addressed...as I do not think a 4th is in the future from reading this...not good news from a printer that has been so reliable since the 1604...not impressed
  12. How can I disable my SharpCut's safety sensors?

    Definitely not advising as it is a super safety issue if you are in close proximity during operation....although we have ours disabled for the very same reason...you need a volt meter/ tester to jump out or close the circuit. If you have reserve...consult electrician.... Remove bars and you are...
  13. S

    We had the CET flatbed and hybrid....the hybrid used the spectra 15pl heads...I always kept 2 on...

    We had the CET flatbed and hybrid....the hybrid used the spectra 15pl heads...I always kept 2 on hand for a just in case moment... I never used them. Want to contact me...not sure if we are suppose to promote/sell on the forum...advise if ok... pics attached see if this helps....one in box from...
  14. FREE CET Flatbed Printer

    I have 2 spectra heads unopened
  15. Question V Grooving bit to make french cleats?

    Buy er25 1/2" collet...I have colex and use one
Top