Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ratings Saturn has received

  1. Jburns rated Saturn's post Agree in the thread Help with perf cutting on mimaki cjv 150-75.

    For cutting all the way through a material I don't feel like you can get good, consistent results from a roll cutter without using as...

    Apr 9, 2020
  2. Jburns rated Saturn's post Agree in the thread DIY Anti-Static.

    If you're working in a smaller office/shop you might think about picking up a cheap hygrometer (humidity sensor) from Amazon too....

    Mar 25, 2020
  3. Pixels Are Bad Mmmkay? rated Saturn's post Agree in the thread What does this problem look like to you?.

    I've never had good luck cleaning material unless it was do-or-die. I just make sure the platen and rollers are relatively clean and...

    Mar 16, 2020
  4. Pixels Are Bad Mmmkay? rated Saturn's post Agree in the thread What does this problem look like to you?.

    Looks like simple dust to me. Tim's suggestions are sound. Keeping the shop relative humidity at 40-60% can help keep the dust out of...

    Mar 16, 2020
  5. TimToad rated Saturn's post Agree in the thread What does this problem look like to you?.

    I've never had good luck cleaning material unless it was do-or-die. I just make sure the platen and rollers are relatively clean and...

    Mar 15, 2020
  6. Jburns rated Saturn's post Agree in the thread Are there "best practices" for contour cut lines?.

    What software and what cutter are you using? It sounds like you're doing printed stickers/decals, and not just cutting colored vinyl? I...

    May 26, 2019

 


Loading...