I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Sorry
How do you make sign patterns in the field on large cabinet pan face signs ( 12' wide X 6'6" tall ) with radius corners? We are ordering new faces. The sign is about 20' off the ground and we have one bucket truck.
Thanks
Well I went out and bought 12 2" corner rounders and will see how that works. But, seriouly I thought some company might make the blanks. So we are going to make them ourself.
Thank you all for your suggestions and even 12 2" corner rounders.
:banghead:Help!!!!! How do you reset the WarpNine parallel driver in Gerber ? Tony from Gerber gave us what the setting should be but we cann't figure out how to reset it.
We have the same computer and software for the Gerber that we were running at our old shop with the exception of some new software for our Epson GS6000. The Epson is running on a ethernet cable and has a static IP address. All of which was setup by our vendor when the the Epson arrived. Thanks, Tom
We just move into our new shop and I am having a problem with our Edge ( Bought new in 2002 ) . When I send a job to be printed I get a error message that reads ( Out dated parallel port devise driver, obtain a new version). The system was working fine at the old shop. Everything that goes to...
Gerber Edge Problem
We just move into our new shop and I am having a problem with our Edge ( Bought new in 2002 ) . When I send a job to be printed I get a error message that reads ( Out dated parallel port devise driver, obtain a new version). The system was working fine at the old shop...
We are having our new one delivered tomorrow and we can hardly wait. Will be giving everyone feedback in the next 2 or 3 wks. So stay tuned.:wine-smi:Tom
Hi Everyone just want to thank everybody again for their feedback and our new Epson 6000 will be arriving around the middle of this month and we are really looking forward to start using it:toasting::toasting:.We will give everyone a update on how it is going.
Tom Shelton
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.