I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Ok, I've taken pictures of where I am so far.
I've had my headboard serviced by a tech and he put in 2 new transistors and 2 new fuses.
When I got my headboard back before I installed it back in I noticed some of my ribbon cables were crossed... 2 were in the wrong connector port. So before I...
Can someone show me where I can double check that I have the ribbon cables connected properly. I switched them to the correct position from visually looking at the other banks but now I just need to be sure I have it right!
Yess I think you're right. thank you when you said this I immediately went and checked the cable connectors and realized I had 2 cables crossed! when I switched them back to the correct connector that ribbon sparked then smoked! I then checked my fuses and I blew 1 of them. What should I try...
Thanks . when you said this I immediately went and checked the cable connectors and realized I had 2 cables crossed into the wrong ports! when I switched them back to the correct connector that ribbon sparked then smoked! I then checked my fuses and I blew 1 of them. What should I try now? I...
Yes he replaced 2 of my transistors. We put a new fuse in and now the yellow and black came back but the cyan and magenta are not firing.... i tested the fuse and I think it's blown.
So I purchased a OHM reader to test the 3 fuses on my headboard and the readings are all different. I recently sent my board out for repair and my tech put in 2 new fuses and left my old one in that was giving good readings.
I turned on the machine and did a test print and bank C is not firing...
I thought about doing that but because the printer will not allow me to get itnto service mode. (its locked me out) im convcerned that if I discounnted the pump it will read an error that its disconnected and to reconnect it first.
Thanks, do you know what the cleaning cartridge is used for? Im about to buy the below cleaning cartridge for 39 bucks at Grimco.com and allow it to dump that cleaner out instead of my expensive inks. What do we use the cleaner for? Do you think this would work?
20/20 Cleaning Cartridge – 220...
I am in need to buy the after market 20/20 Color Roland 22 Series Ink - I will be in Orlando on Monday so if you know any in Florda I am willing to drive and pick-up. I can't afford to wait I need it on monday for the light cyan and cyan inks.
do you know if there is anyway to get around having the printer dump my inks? When I turn on the printer it asks me to "set ink type" when I select the option that its a CMYKLCLM inks it then asks me to confirm drain bottle is in place - when I select enter it one by one goes thru each ink color...
Thanks Joe . - I called Grimco and they are sending replacements - I think you're right must be the chip
Also, do you know if there is anyway to get around having the printer dump my inks? When I turn on the printer it asks me to "set ink type" when I select the option that its a CMYKLCLM inks...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.